As a vehicle travels through a corner, the flowfield observed from the vehicle's frame of reference becomes curved. This condition results in the relative flow angle and freestream velocity changing both across the width and along the length of the body. Wall-resolved Large Eddy Simulations were used to simulate a simple vehicle shape through three different radii corners. The variable flow angle and acceleration affected the pressure distribution along either side of the body and caused an increase in the size of the outboard C-pillar vortex, and an inboard decrease. Furthermore, an outboard extension of the separation bubble at the bluff trailing face resulted in a gentler downwash angle off the backlight surface, with the opposite occurring inboard. At a Reynolds number of 1.7 Â 10 6 , a 19.2% increase in aerodynamic drag occurred for a five car-length radius corner when compared to the straight-line condition. In addition, a yawing moment acted against the rotation of the body through the corner, and a side force acted towards the centre of the corner. An exponential trend related the curvature of a vehicle's path to the increase in aerodynamic drag, with a linearity exhibited for the increase in yawing moment and side force.

For inverted wings in close ground proximity, such as race car configurations, the aerodynamic ground effect can produce local velocities significantly greater than the freestream and the effects of compressibility may occur sooner than would be expected for a wing that is not close to a ground plane. A three-dimensional computational fluid dynamics study was conducted, involving a modified NASA GA(W)-2 LS [1]-0413 MOD inverted wing with an endplate, to investigate the onset and significance of compressibility for low subsonic Mach numbers. With the wing angle of incidence fixed, Mach numbers from 0.088 to 0.4 were investigated, at ground clearances ranging from infinite (free flight) to a height-to-chord clearance of 0.067. The freestream Mach number at which flow compressibility significantly affects the predicted aerodynamic coefficients was identified to be as low as 0.15. Beyond this point, as the compressible flow conditions around the wing result in changed pressure distribution and separation behavior, treating the flow as incompressible becomes inappropriate and leads to consistent underprediction of lift and drag. The influence on primary vortex behavior of density changes around the wing was found to be relatively inconsequential even at the higher end of the Mach scale investigated. By a freestream Mach number of 0.4 and at low clearances, local supersonic flow regions were established close to the suction peak of the lower wing surface in compressible simulations; the formation of a normal shock wave between the wing and the ground was shown to result in significant increases in separation and therefore overall drag, as well as a distinct loss of downforce.

a b s t r a c tIn order to study the aerodynamic forces and flow features of rotating wheels, compromises and simplifications are often made in wind tunnel testing, and more frequently so in numerical modelling. A CFD approach similar to that commonly used in industry was utilised to investigate common assumptions involving; the influence of geometric fidelity in wheel hub regions, ground representation, the modelling of the contact patch, and the effects of rotation on separation. It was found that the separation and wake characteristics were strongly influenced by the rotation of the wheel; the separation point changed by as much as 90% compared to a stationary wheel, and drag was close to 20% less -downforce was approximately 40% greater. In addition, the modelling of the contact patch, treated here as a small step to facilitate skew-free meshing necessary for a reliable converged result, was seen to cause up to a 52% difference in predicted lift characteristics, and an increase in the step of just 2 mm decreased the maximum wake thickness by close to 50% -considerable changes stemming from superficially-minor simplifications. Including indented wheel hubs proved to be more influential on the production of vortices and wake structures, causing the merging of previously-separate vortex structures. The results point to a need for very careful evaluation of the goals of any study when determining which simplifications can be made in both physical testing and numerical analysis.

No abstract