This paper presents an original model of powder bed generation developed within the frame of an integrated modelling approach for studying the interaction of physical mechanisms in additive layer manufacturing (ALM) of orthopaedic implants. The model is based on cellular automata (CA) approach and describes the relationship between moving particles of different sizes during deposition on a surface in three dimensions. The surface is defined by the horizontal two-dimensional CA on which particles fall and irreversibly stick to a growing deposit. The model allows for consideration of different restructuring cases when particles are allowed to rotate as often as necessary until achievement of a local minimum position. Changes in the packing density of the powder bed have been investigated numerically depending on technological parameters, such as particle size distribution, deposition rate and sequence of powder deposition. The model has been developed with the aim of merging to the finite element (FE)-based integrated model and is applicable to a different ranges of materials including metals and also non-metals.

In this study, we report on a group of complementary human osteoblast in vitro test methods for the preclinical evaluation of 3D porous titanium surfaces. The surfaces were prepared by additive manufacturing (electron beam melting [EBM]) and plasma spraying, allowing the creation of complex lattice surface geometries. Physical properties of the surfaces were characterized by SEM and profilometry and 3D in vitro cell culture using human osteoblasts. Primary human osteoblast cells were found to elicit greater differences between titanium sample surfaces than an MG63 osteoblast‐like cell line, particularly in terms of cell survival. Surface morphology was associated with higher osteoblast metabolic activity and mineralization on rougher titanium plasma spray coated surfaces than smoother surfaces. Differences in osteoblast survival and metabolic activity on titanium lattice structures were also found, despite analogous surface morphology at the cellular level. 3D confocal microscopy identified osteoblast organization within complex titanium surface geometries, adhesion, spreading, and alignment to the biomaterial strut geometries. Mineralized nodule formation throughout the lattice structures was also observed, and indicative of early markers of bone in‐growth on such materials. Testing methods such as those presented are not traditionally considered by medical device manufacturers, but we suggest have value as an increasingly vital tool in efficiently translating pre‐clinical studies, especially in balance with current regulatory practice, commercial demands, the 3Rs, and the relative merits of in vitro and in vivo studies. Biotechnol. Bioeng. 2016;113: 1586–1599. © 2015 The Authors. Biotechnology and Bioengineering Published by Wiley Periodicals, Inc.