A cationic surfactant (tetra-n-butyl ammonium chloride) incorporated into electrospun PVDF enhanced the β-phase of PVDF and thereby the piezoelectric response of the nanogenerator based on it.

Herein, we report the physicochemical characteristics and piezoresistive strain sensing performance of flexible thin film comprising graphene and bio‐based thermoplastic polyurethane (TPU) prepared by solution cast method. A detailed analysis was carried to study the influence of graphene nanoplatelets on the morphological, thermal, mechanical, and electrical properties of TPU nanocomposite. Upon increasing the graphene nanoplatelets loading, the thermal stability and tensile properties improved remarkably, while glass transition temperature decreased slightly. Owing to better dispersion of graphene, the electrical conductivity was significantly increased, which broaden the utilization of the nanocomposite for various applications. The piezoresistive sensor was able to respond to various stress modes such as tapping, bending, and finger touch. The piezoresistive sensor was sensitive and achieved a gauge factor of 11. Sensor attached to finger, showed distinctive response upon bending at different angles and showed high stability and reproducibility even after >10,000 cycles under repetitive constant load. Also, the nanocomposite was able to detect any breakage or fracture in the form of change in electrical resistance. A combination of bio‐based TPU and graphene offered improved physical properties and high sensing performance, which could be a potential material in flexible electronics and structural health monitoring systems.

No abstract

Lead-free flexible piezoelectric and triboelectric nanogenerators are sought after due to their ability to produce electricity by harnessing wasteful mechanical energy. A comprehensive understanding of additives and processing techniques is crucial for fine-tuning the performance of such energy systems. We have investigated in detail the effect of the addition of reverse microemulsion synthesized barium tungstate nanorods (BWN) on morphology, crystallinity, polymorphism of electrospun nanofabrics of poly(vinylidene fluoride) (PVDF). The electroactive phase content of the nanofabrics was enhanced upon the addition of BWN and the highest electroactive phase content of 86.5% was observed in the nanofabric containing 3 wt% of BWN. The dielectric constant of the nanofabric containing 5 wt% BWN was ~1.96 times higher than that of pristine PVDF nanofabric (EPVDF). The ratio of relative change in the capacitance to initial capacitance of the sensor fabricated from the same system was ~4 times greater than that of EPVDF. Consequently, its piezoelectric and triboelectric performances were improved. The piezoelectric nanogenerator fabricated using the nanofabric containing 3 wt% BWN produced the highest open-circuit voltage of 8 V under an applied load of 8 N. A triboelectric nanogenerator made using the same system was able to produce a voltage output of 200 V, which was 1.77 times as high as that of EPVDF under one-finger tapping in contact-separation mode. The same composite nanofabric produced piezoelectric and triboelectric power densities of 4.3 µW/cm2 and 646 µW/cm2, respectively. The triboelectric nanogenerator was able to light forty LEDs under one finger tapping. Fluttering-driven triboelectric nanogenerator fabricated using the aforementioned nanofabric was able to produce a triboelectric voltage of 84 V at a wind speed of 7 m/s. Overall, these nanofabrics could be a potential material for energy harvesting devices for powering wearable devices, environmental sensors, and internet of things.