We measure the magneto-conductance through a micron-sized quantum dot hosting about 500 electrons in the quantum Hall regime. In the Coulomb blockade, when the island is weakly coupled to source and drain contacts, edge reconstruction at filling factors between one and two in the dot leads to the formation of two compressible regions tunnel coupled via an incompressible region of filling factor ν = 1. We interpret the resulting conductance pattern in terms of a phase diagram of stable charge in the two compressible regions. Increasing the coupling of the dot to source and drain, we realize a Fabry-Pérot quantum Hall interferometer, which shows an interference pattern strikingly similar to the phase diagram in the Coulomb blockade regime. We interpret this experimental finding using an empirical model adapted from the Coulomb blockaded to the interferometer case. The model allows us to relate the observed abrupt jumps of the Fabry-Pérot interferometer phase to a change in the number of bulk quasiparticles. This opens up an avenue for the investigation of phase shifts due to (fractional) charge redistributions in future experiments on similar devices. :1910.12525v1 [cond-mat.mes-hall] arXiv

In the fractional quantum Hall effect, the elementary excitations are quasi-particles with fractional charges as predicted by theory and demonstrated by noise and interference experiments. We observe Coulomb blockade of fractional charges in the measured magneto-conductance of a 1.4-micron-wide quantum dot. Interaction-driven edge reconstruction separates the dot into concentric compressible regions with fractionally charged excitations and incompressible regions acting as tunnel barriers for quasi-particles. Our data show the formation of incompressible regions of filling factors 2/3 and 1/3. Comparing data at fractional filling factors to filling factor 2, we extract the fractional quasi-particle charge e*/e = 0.32 ± 0.03 and 0.35 ± 0.05. Our investigations extend and complement quantum Hall Fabry-Pérot interference experiments investigating the nature of anyonic fractional quasi-particles.

Scalable architectures for quantum information technologies require one to selectively couple long-distance qubits while suppressing environmental noise and cross talk. In semiconductor materials, the coherent coupling of a single spin on a quantum dot to a cavity hosting fermionic modes offers a new solution to this technological challenge. Here, we demonstrate coherent coupling between two spatially separated quantum dots using an electronic cavity design that takes advantage of whispering-gallery modes in a two-dimensional electron gas. The cavity-mediated, long-distance coupling effectively minimizes undesirable direct cross talk between the dots and defines a scalable architecture for all-electronic semiconductor-based quantum information processing.

Experiments performed at a temperature of a few millikelvin require effective thermalization schemes, low-pass filtering of the measurement lines and low-noise electronics. Here, we report on the modifications to a commercial dilution refrigerator with a base temperature of 3.5 mK that enable us to lower the electron temperature to 6.7 mK measured from the Coulomb peak width of a quantum dot gate-defined in an [Al]GaAs heteostructure. We present the design and implementation of a liquid 4 He immersion cell tight against superleaks, implement an innovative wiring technology and develop optimized transport measurement procedures. arXiv:1909.10906v1 [cond-mat.mes-hall]

No abstract