No abstract

No abstract

No abstract

No abstract

No abstract

Maintenance procedures of different wood coating systems were studied in field exposure trials with coated balcony constructions. Maintenance coatings were applied on one half of each of the balcony parts after 18 months and assessed after 24 months of total exposure time. It was found that the opaque white coating systems were the most durable ones reaching long intervals of required maintenance. For systems with lower durability on the maintained surfaces further degradation of the coatings was prevented. Different characteristics were observed for film forming and non film forming semi-transparent varnishes. Definitions of a series of limit states for coating systems on wood were suggested including esthetical limits and three levels of durability limits. Film forming coatings can reach two durability limits, i.e. the maintenance interval and the renovation interval. For non film forming coatings there is only one limit state of coating durability where maintenance is needed. The third durability limit is related to the coated substrate, i.e. the wood component, by the onset of decay in wood. Wartungsmaßnahmen und Definition von Grenzzuständen für HolzaußenbeschichtungenZusammenfassung Wartungsmaßnahmen von verschiedenen Beschichtungssystemen für Holz wurden in Freilandbe-G. Grüll ( ) · M. Truskaller

No abstract

Wood moisture content of coated panels of Scots pine sapwood was recorded during 18 months natural weathering in Vienna by logging electric resistance and temperature near the surface. Eight coating systems with various film thicknesses were used, including three solvent borne alkyd stains, three water borne acrylic stains and two water borne acrylic paints. At five sites in Europe wood moisture content of panels coated with three solvent borne alkyd stains, a brow acrylic stain and a white opaque acrylic paint was recorded weekly by changes in panel mass. Fluctuations in wood moisture content were influenced by the film thickness, moisture protection and colour of the coating systems used. Degradation phenomena led to decreasing moisture protection of less durable coating systems over time of exposure. Differences between the exposure sites were relatively low, except the site in the UK where moisture conditions were higher.