Three different magnetic samples with particle sizes ranging from 10 to 30 nm were prepared by wet chemical methods. The powders were heated at 100, 150, 200, and 250 °C during 30 min under air. Ferrous and total iron contents were determined immediately after the synthesis and after the thermal treatments. All samples were characterized by X-ray diffraction, transmission and integral low-energy electron Mössbauer spectroscopy (ILEEMS) at 298 K. These samples are composed of a mixture of individual particles of maghemite and magnetite, which implies that once oxidation starts in this kind of material, it occurs throughout the entire particle volume. The existence of a maghemite/magnetite core-shell model was ruled out. A linear correlation between the average isomer shift and the magnetite content was found, allowing the estimation of the amounts of magnetite and maghemite in an unknown sample without the need of performing chemical analysis.

No abstract

Abstract--Several samples of large-and small-particle magnetite (Fe304), as well as its thermal decomposition products formed at different temperatures and atmospheres, have been studied extensively by Mrssbauer spectroscopy (MS), both with and without an applied field of 6T. Synthetic mixtures of magnetite and poorly-or well-crystallized maghemite have also been studied. Large-particle magnetite (MCD > 200 nm), when heated in air for 12 hours at T < 400*(2, transforms to a mixture of wellcrystallized hematite and magnetite, the latter one remaining stoichiometric, according to the relative area-ratios obtained from MS. Thermal treatment at 1300"C in a controlled 02 partial pressure, produced a mixture of stoichiometric and nonstoichiometric magnetite, but the latter component seems to be composed of particles with different degrees of nonstoichiometry. The Mrssbauer spectra of the decomposition products at T < 200"C in air of small-particle magnetite (MCD ~ 80 nm) could be successfully interpreted as a mixture of magnetite and maghemite, rather than nonstoichiometric magnetite. This suggestion is further supported by the experiments with the synthetic mixtures. It is clearly demonstrated that is not possible, even by applying a strong external field, to separate the contribution of the A-site of magnetite from that of maghemite.

No abstract

No abstract

The Capim Kaolin District (eastern Brazilian Amazon), is one of the largest kaolin deposits in the world; with the kaolin used mainly for paper coating. The kaolin developed at the expense of Cretaceous sandy-clayey sediments of the Ipixuna formation, through intense lateritization from the Mesozoic to Cenozoic times.This work describes the morphological, mineralogical, crystallochemical and geochemical evolution of the Capim kaolin facies. Based on the profile analysis in the open pit fronts, it encompasses X-ray diffraction, thin-section optical analysis, EDS-assisted scanning electron microscopy and transmission electron microscopy, chemical analysis, infrared and Mössbauer spectroscopies.Six facies were defined as different stages of the supergene process. Ferruginization led to a thick duricrust on the soft kaolin, which in turn evolved from sandy-clayey sediments of the Ipixuna Formation. A subsequent deferruginization event degraded the duricrust, resulting in the flint kaolin facies.

No abstract

Abstract--Synthetic, relatively well-crystallized aluminum-substituted maghemite samples, y-(Aly. Fe~_y)203, with y = 0, 0.032, 0.058, 0.084, 0.106 and 0.151 have been studied by X-ray diffraction and zero-field Mrssbauer spectroscopy in the range 8 K to 475 K, and also with an external field of 60 kOe at 4.2 K and 275 K. It was found that there are two different converging models for fitting the zero-field spectra of the maghemites with a superposition of two Lorentzian-shaped sextets, both resulting in inconsistent values for the hyperfine fields (Hhf) and/or the center shifts (6) of the tetrahedral (A) and octahedral (B) ferric ions. From the applied-field measurements it is concluded that there is a constant difference of 0.12 _+ 0.01 mm/s between 6B and 6A, regardless of the A1 content.