No abstract

The performance of the diffusive gradient in thin film technique (DGT) was evaluated as a tool for the long-term monitoring of water quality, using uranium as a case study. DGTs with a Metsorb™ (TiO2) sorbent were deployed consecutively at two alkaline freshwater sites, the River Enborne and the River Lambourn, UK for seven-day intervals over a five-month deployment period to obtain time weighted average concentrations. Weekly spot samples were taken to determine physical and chemical properties of the river water. Uranium was measured in these spot samples and after extraction from the DGT devices. The accuracy of the DGT device time weighted average concentrations to averaged spot water samples in both rivers was 86% (27 to 205%). The DGT diffusive boundary layer (DBL) (0.037-0.141 cm - River Enborne and 0.062-0.086 cm - River Lambourn) was affected by both water flow and biofouling of the diffusion surface. DBL thicknesses found at both sites were correlated with flow conditions with an R(2) value of 0.614. Correlations were also observed between the DBL thickness and dissolved organic carbon (R(2) = 0.637) in the River Lambourn, indicating the potential presence of a complex zone of chemical interactions at the surface of the DGT. The range of DBL thicknesses found at the River Lambourn site were also attributed to of the development of macro-flora on the active sampling surface, indicating that the DBL thickness cannot be assumed to be water flow dependant only. Up to a 57% under-estimate of uranium DGT concentration was observed compared to spot sample concentrations if the DBL was neglected. This study has shown that the use of DGT can provide valuable information in environmental monitoring schemes as part of a 'tool-box' approach when used alongside conventional spot sampling methods.

Commercially available Diphonix(®) resin (TrisKem International) was evaluated as a receiving phase for use with the diffusive gradients in thin-films (DGT) passive sampler for measuring uranium. This resin has a high partition coefficient for actinides and is used in the nuclear industry. Other resins used as receiving phases with DGT for measuring uranium have been prone to saturation and significant chemical interferences. The performance of the device was evaluated in the laboratory and in field trials. In laboratory experiments uptake of uranium (all 100% efficiency) by the resin was unaffected by varying pH (4-9), ionic strength (0.01-1.00 M, as NaNO3) and varying aqueous concentrations of Ca(2+) (100-500 mg L(-1)) and HCO3(-) (100-500 mg L(-1)). Due to the high partition coefficient of Diphonex(®), several elution techniques for uranium were evaluated. The optimal eluent mixture was 1M NaOH/1M H2O2, eluting 90% of the uranium from the resin. Uptake of uranium was linear (R(2)=0.99) over time (5 days) in laboratory experiments using artificial freshwater showing no saturation effects of the resin. In field deployments (River Lambourn, UK) the devices quantitatively accumulated uranium for up to 7 days. In both studies uptake of uranium matched that theoretically predicted for the DGT. Similar experiments in seawater did not follow the DGT theoretical uptake and the Diphonix(®) appeared to be capacity limited and also affected by matrix interferences. Isotopes of uranium (U(235)/U(238)) were measured in both environments with a precision and accuracy of 1.6-2.2% and 1.2-1.4%, respectively. This initial study shows the potential of using Diphonix(®)-DGT for monitoring of uranium in the aquatic environment.