In this study, we grew Cu co-doped single crystals of a topological superconductor candidate SrxBi2Se3, and studied their structural and transport properties. We reveal that the addition of even as small an amount of Cu co-dopant as 0.6 atomic %, completely suppresses superconductivity in SrxBi2Se3. Critical temperature (∼2.7 K) is rather robust with respect to co-doping. We show that Cu systematically increases the electron density and lattice parameters a and c. Our results demonstrate that superconductivity in SrxBi2Se3-based materials is induced by significantly lower Sr doping level x<0.02 than commonly accepted x∼0.06, and it strongly depends on the specific arrangement of Sr atoms in the host matrix. The critical temperature in superconductive Sr-doped Bi2Se3 is shown to be insensitive to carrier density.
Widespread use of Mg-Zn-Ca alloys in clinical orthopedic practice requires improvement of their mechanical properties—in particular, ductility—and enhancement of their bioactivity for accelerated osteoreconstruction. The alloy was studied in two structural states: after homogenization and after equal-channel angular pressing. Immersion and potentiodynamic polarization tests showed that the corrosion rate of the alloy was not increased by deformation. The mass loss in vivo was also statistically insignificant. Furthermore, it was found that deformation did not compromise the biocompatibility of the alloy and did not have any significant effect on cell adhesion and proliferation. However, an extract of the alloy promoted the alkaline phosphatase activity of human mesenchymal stromal cells, which indicates osteogenic stimulation of cells. The osteoinduction of the deformed alloy significantly exceeded that of the homogenized one. Based on the results of this work, it can be concluded that the alloy Mg-1%Zn-0.3%Ca modified by equal-channel angular pressing is a promising candidate for the manufacture of biodegradable orthopedic implants since it stimulates osteogenic differentiation and has greater ductility, which provides it with a competitive advantage in comparison with the homogenized state.
The effect of high-pressure torsion (HPT) on the microstructure, phase composition, mechanical characteristics, degradation rate, and bioactive properties of the Zn–1%Mg alloy is studied. An ultrafine-grained (UFG) structure with an average grain size of α-Zn equal to 890 ± 26 nm and grains and subgrains of the Mg2Zn11 and MgZn2 phases with a size of 50–100 nm are formed after HPT. This UFG structure leads to an increase in the ultimate tensile strength of the alloy by ~3 times with an increase in elongation to 6.3 ± 3.3% due to the formation of a basal texture. The study of corrosion resistance did not show a significant effect of HPT on the degradation rate of the alloy. In addition, no significant changes in the bioactivity of the alloy after HPT: hemolysis, cellular colonization and Escherichia coli growth inhibition.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.