No abstract

Background: Advanced computer-aided design and computer-aided manufacturing (CAD-CAM) technology led to the introduction of an increasing number of machinable materials suitable for dental prostheses. One of these materials is polyetheretherketone (PEEK), a high performance polymer recently used in dentistry with favorable physical, mechanical and chemical properties. The purpose of this study was to review the current published literature on the use of PEEK for the fabrication of dental prostheses with CAD-CAM techniques. Methods: Electronic database searches were performed using the terms "PEEK", "CAD-CAM", "dental", "dentistry" to identify studies related to the use of PEEK for the fabrication of CAD-CAM prostheses. The search period spanned from January 1990 through February 2020. Both in vivo and in vitro studies in English were eligible. Review articles and the references of the included publications were searched to identify relevant articles. Results: A great number of in vitro studies are available in the current literature pointing out the noticeable properties of PEEK. The use of PEEK has been recommended for a wide range of CAD-CAM fabricated fixed and removable dental prostheses. PEEK was additionally recommended for occlusal splints, intra-radicular posts, implant abutments, customized healing abutments and provisional restorations. However, only a few clinical studies were identified. Conclusions: PEEK could be considered as a viable alternative for CAD-CAM fixed and removable dental prostheses to well-established dental materials. Due to the scarcity of clinical data, clinical trials are needed to assess the longterm performance of PEEK prostheses.

Background The purpose of this paper is to review the available literature on three-dimensionally printed complete dentures in terms of novel biomaterials, fabrication techniques and workflow, clinical performance and patient satisfaction. Methods The methodology included applying a search strategy, defining inclusion and exclusion criteria, selecting studies and forming tables to summarize the results. Searches of PubMed, Scopus, and Embase databases were performed independently by two reviewers to gather literature published between 2010 and 2020. Results A total of 126 titles were obtained from the electronic database, and the application of exclusion criteria resulted in the identification of 21 articles pertaining to printed technology for complete dentures. Current innovations and developments in digital dentistry have successfully led to the fabrication of removable dental prostheses using CAD/CAM technologies. Milled dentures have been studied more than 3D printed ones in the currently available literature. The limited number of clinical studies, mainly case reports, suggest current indications of 3D printing in denture fabrication process to be custom tray, record bases, trial, interim or immediate dentures but not definitive prostheses fabrication. Limitations include poor esthetics and retention, inability to balance occlusion and low printer resolution. Conclusions Initial studies on digital dentures have shown promising short-term clinical performance, positive patient-related results and reasonable cost-effectiveness. 3D printing has potential to modernize and streamline the denture fabrication techniques, materials and workflows. However, more research is required on the existing and developing materials and printers to allow for advancement and increase its application in removable prosthodontics.

No abstract

No abstract