No abstract

This article focuses on the impact of fly ash from the combustion of municipal sewage sludge (FAMSS) as a cement additive in the amounts of 5%, 10%, 15%, 20% and 25% (by mass) on selected concrete properties. In the course of the experimental work, water penetration depth and compressive strength measurements were made at various periods of curing (from 2 to 365 days). In addition, the potential impact of FAMSS on the natural environment was examined by determining the leachability of heavy metals. FAMSS-modified concretes showed small values of water penetration depth (lower than 50 mm), as well as good compressive strength (reaching minimum class C30/37 after 130 days of maturing)—similar to the compressive strength obtained for conventional concrete. In addition, the partial replacement of cement with FAMSS has environmental benefits, expressed as a reduction in CO2 emissions. In addition, study has shown that compliance with environmental requirements is associated with heavy metal leaching.

On the basis of the registered indications of the water meter, a study on the size and variability of water consumption on the WULS campus in the academic years 2012/16 is presented. The average specific water consumption at a time when classes are implemented amounted to 26.6 dm 3 per student per day for full-time studies student and 19.7 dm 3 per student per day for the student part-time studies. During the holiday season, the rates are lower at 18.4 and 11.8 dm 3 per student per day, respectively. These ratios were determined without taking the water consumption in the dorms into account. The daily peaking factor amounted (N d) to 1.36, while the hourly peaking factor (N h), reached 1.71. Within the week cycle, the highest water consumption was observed in Tuesdays and the lowest-in Sundays. The average Tuesday demands are 40% higher than the Sunday demands. The water consumption peaks during the day occur between 11 a.m. and 1 p.m. as well as 11 p.m. and 1 a.m. The hourly structure of the water distribution in the WULS-SGGW campus is similar to the weekend structure of water distribution in multi-family residential buildings, with the exception of the later occurrence of the evening summit.

Concrete is the most commonly used structural material, without which modern construction could not function. It is a material with a high potential to adapt to specific operating conditions. The use of this potential is made by its material modification. The aim of the performed investigations was the assessment of rational application possibilities of fly ashes from thermally conversed municipal sewage sludge as an alternative concrete admixture. A concrete mix was designed, based on the Portland cement CEM I 42.5R and containing various quantity of ash, amounting to 0–25% of cement mass. The samples were conditioned and heated in a furnace at the temperature of 300 °C, 500 °C, and 700 °C. Physical and chemical properties of the ashes as well as utility properties of the concrete, i.e., density, compressive strength after 28, 56, and 90 days of maturation, frost resistance, and compressive strength in high temperature were determined. The tests were performed at cubic samples with 10 cm edge. The replacement of a determined cement quantity by the fly ashes enables obtaining a concrete composite having good strength parameters. The concrete modified by the fly ashes constituting 20% of the cement mass achieved its average compressive strength after 28 days of maturation equal to 50.12 MPa, after 56 days 50.61 MPa and after 90 days 50.80 MPa. The temperature growth weakens the composite structure. The obtained results confirm the possibility of waste recycling in the form of fly ashes as a cement substitute in concrete manufacturing.

No abstract