Dependences on the hardening factor for the drawing stress, the safety factor of I.L. Perlin and the stress
state indicator V.L. Kolmogorov at different values of the drawing angle, coefficient of friction and stress of back
tension are presented. For the first time, the nature of the dependences for the limiting and permissible values
of delta-criterion is shown for the shape of the deformation zone of round solid profile on the coefficients of
friction, hardening and safety factor and the back tension stresses. The limiting and permissible values of the
delta-criterion increase from increase in the coefficients of friction and safety factor, the back tension stress and
decrease from increase in the hardening coefficient. It is shown that for small values of the criterion ∆ < 1.5, the
drawing stress can be higher than the yield point at the die output. As result, the wire material may be destroyed
and the drawing process cannot be realized. Assessment of the change degree in the limiting and permissible values
of the elongation coefficient and delta-criterion is carried out with increase in the friction coefficient from 0.05 to
0.15, the back tension from 0 to 85 MPa, the safety factor from 1.0 to 1.4, the hardening coefficient from 0 to k.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.