The problem of predicting flow between rotating eccentric cylinders with axial throughput is studied. The system models a device used to test the stability of emulsions against changes in drop size distribution. The analysis looks for the major variation in flow properties which could put an emulsion at risk due to coalescence or breakage and finds the most likely candidate in the pressure gradient defined as the ratio of the difference between the maximum and minimum pressure to the arc length between the difference. The axial throughput is modeled by flow driven by a constant pressure gradient. The flow is calculated from the Navier-Stokes equation using the code SIMPLER (Patankar [1]). The effects of inertia at values typical for the device are studied. Several eccentricities and different rotational speeds are computed to sample the changes in flow and stress parameters in the idealized device for typical conditions. The numerical analysis is validated against the lubrication approximation in the low Reynolds number case. Conditions for stress induced cavitation are evaluated.The flow is completely determined by a Reynolds number, an eccentricity ratio and a dimensionless pressure gradient and all computed results are either presented or can be easily expressed in terms of these dimensionless parameters.The effect of inertia is to shift the eddy or re-circulation zone which develops in the more open region of the gap toward the region of low relative pressure; the zero of the relative pressure migrates away from the center and the distribution breaks the skew symmetry of the Stokes flow solution.The state of stress in the journal bearing is analyzed and a cavitation criterion based on the maximum tensile stress is compared with the traditional criterion based on pressure.
The numerical simulation of a static T-type mixer for turbulent mixing of miscible liquids is reported. The simulation was carried out using CFX, a commercial computational fluid dynamic simulator. The effect of mixing intensification caused by turbulence generators placed downstream of the injection point of the Tee was evaluated in terms of reduction in mixing length for a given mixture quality, uniformity of turbulence intensity and efficiency of energy conversion to useful mixing energy.The mixing quality for an intensified and conventional T-type mixer was compared, and the turbulence generator geometry was optimized. Main stream Reynolds numbers between 50000 and 100000 were considered for additive volume ratios in the range 0.1 -10%. Selected simulations were validated with experimental data available in the literature for conventional smooth T-type mixers (no ribs).Results were in good agreement with experimental correlations available at high Reynolds numbers.Simulations demonstrated that mixing enhancement was efficient with turbulence generators, extending the Reynolds number range for which compact, low pressure-drop devices may be used for intense mixing. The optimum geometry for turbulence generators was evaluated using criteria based on energetic and spatial efficiency and in all cases the simple Tee was used as the point of reference.Finally, practical design correlations are presented to enable the mixing quality of two miscible streams to be estimated for a simple Tee with and without additional turbulence generators over a range of Reynolds numbers and injection conditions.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.