The distribution and speciation of toxic metals in industrial wastewater sludge (IWS) was investigated. In this work, the modified BCR three-stage sequential extraction procedure was applied to the fractionation of Cr Pb Ni, and Cd in untreated industrial wastewater sludge from industrial sites in Hyderabad (Pakistan). The extracts were analyzed using electrothermal atomic absorption spectrometry. The procedure was evaluated using a certified reference material for soil mixed with sewage sludge BCR 483. The results from the partitioning study indicate that more easily mobilized forms (acid exchangeable) of Cd were dominant. The oxidizable fraction was dominant for all four toxic metals. Metal recovery was good, with <4% difference between the total metal recovered through the extractant steps and the total metal determined after microwave digestion. Lixiviation tests (DIN 38414-S4) were used to evaluate the leaching of toxic species from IWS, and it was observed that levels of leachable toxic metals were low compared to the amount of metal extracted in the exchangeable fraction of the BCR protocol.

No abstract

The determination of toxic metals in the biological samples of human beings is an important clinical screening procedure. This study aimed to assess the possible influence of environmental exposure on production workers (PW) and quality control workers (QCW) of a steel mill, all male subjects aged 25-55 years. In this investigation, the concentrations of Pb, Cd, Ni and Cr were determined in biological samples (blood, urine and scalp hair samples) from these steel mill workers in relation to controlled unexposed healthy subjects of the same age group. After pre-treatment with nitric acid-hydrogen peroxide, the samples were digested via a microwave oven, and for comparison purposes, the same samples were digested by the conventional wet acid digestion method. The samples digested were subjected to graphite furnace atomic absorption spectrometry (GFAAS). To assess the reliability of these methods, critical factors, such as detection limit(s), calibration range(s), accuracy and precision, were studied. Quality control for these procedures was established with certified sample of human hair, urine and whole blood. The results indicate that the level of lead, cadmium and nickel in scalp hair, blood and urine samples were significantly higher in both groups of exposed workers (QW and PW) than those of the controls. The possible connection of these elements with the etiology of disease is discussed. The results also show the need for immediate improvements in workplace ventilation and industrial hygiene practices.

No abstract

The development of 3 different ultrasonic-based sample treatment methods, ultrasonic probe-assisted acid extraction, ultrasonic-assisted acid slurry, and ultrasonic-assisted acid pseudodigestion is presented. These methods were compared for the determination of Cd and Pb by electrothermal atomic absorption spectrometry in biological samples (blood and scalp hair) and validated by using certified materials BCR 397 human hair and BCR 185R bovine liver. The sample amounts chosen to perform the analysis were 100 mg and 0.5 mL for solids (human hair and bovine liver) and blood samples, respectively. An acid digestion induced by microwave energy was used to obtain the total metal concentrations and for comparative purposes. The best results were obtained with the ultrasonic-assisted acid pseudodigestion, with which it was possible to perform accurate and precise determination of the Cd and Pb contents in 2 certified reference materials and biological samples of 50 normal males of ages 2540 years. The precision of the methods, together with their efficiency, rapidity, low cost, and environmental acceptability, make them good alternatives for the determination of trace metals from biological samples. The precision of the methods for accuracy evaluation, resulting in good agreement according to the t-test for a 95% confidence level, and the relative standard deviations were lower than 10% (n = 10) for all determinations.

No abstract

An ultrasonic-assisted leaching procedure was developed for the determination of heavy elements (As, Cu, Cd, Pb, and Zn) in Certified Reference Material of human hair (CRM 397) provided from the Community Bureau of Reference (BCR) of the Commission of the European Community. Concentrated nitric acid30% hydrogen peroxide (2 + 1) was used for the leaching method. The effects of different factors on acid leaching of elements, such as presonication time (without ultrasonic stirring), sonication or exposure time to ultrasound, and temperature of the ultrasonic bath have been investigated. Optimum values of these parameters were selected for the maximum extraction of heavy metals from CRM BCR 397 and human scalp hair samples of normal healthy males. To check the validity of the proposed method, a wet acid digestion method was used to obtain the total elemental concentration in CRM BCR 397 and scalp hair samples. Cu and Zn in leachate and digests were measured by flame atomic absorption spectrometry using a conventional air/acetylene flame, while As, Cd, and Pd were determined by electrothermal atomic absorption spectrometry. Under optimized conditions, the recovery for Zn, Cd, Pd, As, and Cu was 98, 98.5, 97.5, 98.2, and 95%, respectively, of those obtained with the wet acid digestion method.

The pathogenesis of heart disease has been associated with changes in the balance of certain trace elements. The aim of this study was to evaluate the Zn, Fe, Cu, Cr, Ni, Pb, and Cd contents in scalp hair samples of myocardial infarction (MCI) patients hospitalized in the cardiac ward of National Hospital in Hyderabad city (Pakistan). Scalp hair samples were collected from 193 patients (104 male, 89 female) of 3 age groups (46-60, 61-75, and 76-90 yr), for a comparative study, 200 normal, healthy subjects (103 male, 97 female) of the same age groups residing in the same city were selected. All metals in scalp hair samples were assessed by a flame/ graphite furnace atomic absorption spectrophotometer, prior to microwave-assisted and conventional wet acid digestion methods. Results were calculated in micrograms per gram. The mean values of Fe and Zn of scalp hair samples of MCI patients were significantly reduced compared to the control subjects of both genders. The mean Fe concentrations in male patients were 19.42, 12.36, and 6.98 vs 30.69, 24.42, and 16.75 for the control patients in the three age groups (46-60, 61-75, and 76-90 yrs, respectively). The mean Zn concentration in male patients were 169.2, 149.4, and 107.7 microg/g vs 206.1, 188.0, and 154.4 microg/g for the control group (p < 0.002, 0.004, and 0.001) in all three age groups, respectively. These differences were also observed in the female study groups. The mean values of Pb, Cd, and Ni were significantly high in patients compared to healthy subjects (mean Pb in male patients: 11.85, 12.89, and 14.52 those of female patients were 11.88, 12.73, and 14.21 vs the male controls patients (6.08, 7.56, and 8.56) and female controls (5.99, 7.41, and 8.25) for all three age groups, respectively. The concentration of Ni and Cd in the scalp hair samples of the heart patients of both sexes were significantly higher compared to the control; in the case of Ni the range of significant difference for males was found to be p < 0.001-0.009 and for females to be p < 0.0.002-0.007 and significantly high concentration of Cd were observed in hair samples of patients than in controls in the range for males (p < 0.001-0.009) and in females (p < 0.001-0.011). The Zn/Cu and Zn/Cd ratios in the scalp hair (p < 0.01) of the diseased groups were significantly lower than that of the healthy groups. Deficiency of essential trace metals and high level of toxic metals might play a role in the development of heart disease in the subjects of this study. Toxic metals might also cause diminished absorption of essential elements.