The OPERA neutrino experiment at the underground Gran Sasso Laboratory has measured the velocity of neutrinos from the CERN CNGS beam over a baseline of about 730 km. The measurement is based on data taken by OPERA in the years 2009, 2010 and 2011. Dedicated upgrades of the CNGS timing system and of the OPERA detector, as well as a high precision geodesy campaign for the measurement of the neutrino baseline, allowed reaching comparable systematic and statistical accuracies.An arrival time of CNGS muon neutrinos with respect to the one computed assuming the speed of light in vacuum of (6.5 ± 7.4 (stat.) +8.3 −8.0 (sys.)) ns was measured corresponding to a relative difference of the muon neutrino velocity with respect to the speed of light (v − c)/c = (2.7 ± 3.1 (stat.) +3.4 −3.3 (sys.)) × 10 −6 . The above result, obtained by comparing the time distributions of neutrino interactions and of protons hitting the CNGS target in 10.5 µs long extractions, was confirmed by a test performed at the end of 2011 using a short bunch beam allowing to measure the neutrino time of flight at the single interaction level.

[1] We show the feasibility of a real-time estimation of waveforms and coseismic displacements, within a few centimeters in accuracy, with a stand-alone dual-frequency Global Positioning System (GPS) receiver using a so-called "variometric" approach. The approach is based on time single-differences of carrier phase observations collected at a high-rate (1 Hz or more) using a stand-alone receiver, and on standard GPS broadcast products (orbits and clocks), which are ancillary information routinely available in real time. In the approach, first, the time series of epoch-by-epoch displacements are estimated. Then, provided that the collected observations are continuous, they can be summed over the interval (limited to a few minutes) over which an earthquake occurs. Since epoch-by-epoch displacements divided by the interval between consecutive epochs are essentially equal to the epoch-by-epoch velocities, this is equivalent to saying that we are using the GPS receiver as a velocimeter. Estimation biases, due to the possible mismodeling of various intervening effects (such as multipath, residual clock errors, orbit errors, and atmospheric errors), accumulate over time and display their signature as a trend in coseismic displacements. The trend can be considered linear and easily removed, at least for short intervals. Since the proposed approach (named VADASE (Variometric Approach for Displacements Analysis Stand-alone Engine)) does not require either additional technological complexity or a centralized data analysis, in principle it can be embedded into GPS receiver firmware, thereby providing a significant contribution to tsunami warning and other hazard assessment systems. After a preliminary test using a simulated example, the effectiveness of this approach was proven using real data.

Here, we present the application to the great Tohoku-oki (Japan) earthquake (United States Geological Survey M = 9.0, March 11, 2011, 05: 46: 24 Coordinated Universal Time) of a novel approach, named Variometric Approach for Displacements Analysis Stand-Alone Engine, able to estimate accurate coseismic displacements and waveforms in real time, in the global reference frame, just using the standard broadcast products (orbits and clocks) and the high-rate (1 Hz or more) carrier phase observations continuously collected by a stand-alone global-positioning-system receiver. We processed separately the data collected at MIZU (Mizusawa, 140 km from the epicenter) and USUD (Usuda, 430 km from the epicenter) International Global Navigation Satellite System Service sites. A total horizontal displacement of about 2.4 m east-southeast was estimated for the MIZU, with a maximum horizontal oscillation amplitude of about 3.4 m along the same direction. Generally, an overall accuracy better than 10 cm for all the components (east, north, and up) and an average accuracy around 5 cm were assessed over an interval shorter than 5 min, with respect to independent solutions obtained with two different scientific software. The threshold of 5-cm accuracy has been recently indicated as sufficient for real-time fault determination for near-field tsunami forecasting for a major earthquake, like the 2011 Tohoku-oki one

The Global Positioning System (GPS) has been repeatedly proven to be a powerful tool to estimate coseismic displacements and waveforms, with accuracies ranging from few millimeters to few centimeters. These promising results were achieved following two main strategies: differential positioning (DP) and precise point positioning (PPP;Bock et al. [1993], Kouba [2003], Larson et al. [2007], Larson [2009], Ohta et al. [2012], Xu et al.[2012], and Hung and Rau [2013]). In particular, both the modeling of fault rupture and the seismic moment estimation could benefit from GPS-derived displacements, because GPS is not affected by the saturation problems experienced by seismometers located near the epicenters of strong earthquakes. Thanks to the robustness of the GPS-derived displacement waveforms, in the last years some authors (Bock et al., 2000;Langbein and Bock, 2004;Blewitt et al., 2006;Bock and Genrich, 2006) addressed the problem to retrieve them in real time, with accuracies of a few centimeters, from GPS high-rate observations (1 Hz or more). In this context, the Variometric Approach for Displacements Analysis Standalone Engine (VADASE) has been proposed (Colosimo et al. [2011a], Colosimo [2013]). The approach is based on time single differences of carrier phase observations continuously collected using a standalone GPS receiver and on standard GPS broadcast products (orbits and clocks) that are available in real time. Therefore, one receiver works in standalone mode and the epoch-by-epoch displacements (equivalent to velocities) are estimated. Then, they are summed over the time interval when the earthquake occurred to retrieve displacements. Because VADASE does not require either additional technological complexity or a centralized data analysis, in principle, it can be embedded into the GPS receiver firmware and therefore can work in real time. Moreover, differently from DP and PPP, VADASE does not re-MO05 station (1 Hz observations over 120 s interval

No abstract