No abstract

No abstract

In modern power systems, condition based monitoring and diagnosis is essential to ensure the effective and reliable operation of different high voltage equipment (HVE). Compared to other monitoring techniques, partial discharges (PD) measurement is considered as a key method for assessing the insulation health condition. The benefits of PD condition monitoring of HVE can be extended by proper detection, identification, and interpretation of PD signal. Among both online and offline PD monitoring techniques, online PD monitoring is a very promising technique that assists in robust monitoring system which reduces the power failure incidents in power system components. Therefore, to understand recent developments and trends in theory and in practice, it is necessary to establish a holistic analysis of current online PD monitoring techniques for HVE in power systems. This paper presents an intensive literature review of current online PD monitoring techniques used for different high voltage electric components in power system. Finally, a smart PD monitoring techniques based on wireless sensor board is proposed. The proposed smart PD monitoring framework may be used to correctly estimate the insulation degradation in HVE and enhance the overall performance of power systems. INDEX TERMSDetection methods, feature extraction, high voltage equipment (HVE), online partial discharges (PD) measurement, PD monitoring, PD classification.

No abstract

Partial discharge (PD) measurements have proved their reliability for health monitoring of insulation systems in power system components including synchronous generators, power transformers, switchgear and cables etc. Online condition monitoring and pro-active detection of PD faults have been highly demanded over the last two decades. This paper provides results from a research project to develop advanced non-intrusive sensing technologies that are cost effective, reliable and efficient for early detection of PD faults in medium voltage (MV) and high voltage (HV) air-insulated switchgear. Three sensors (high frequency E-field (D-dot) sensor, Rogowski coil and loop antenna) have been developed and tested under various PD faults and their performance were evaluated in comparison with high frequency current transformer (HFCT) which is being used commercially for PD testing and measurement. Among these three sensors, it is shown that D-dot sensor and Rogowski coil are more dependable when it comes to the PD measurements due to their high signal to noise ratio and hence high accuracy. These sensors can be customized according to a specific application and can be connected together with one data acquisition device while developing an online condition monitoring system.