A real‐time, sensitive, and selective detection device to monitor the healing status of chronic wounds at the point of care is urgently required to render the management of this disease more effective. The photonic properties of porous silicon resonant microcavity (pSiRM) afford an excellent opportunity to be developed as a highly sensitive optical biosensor to monitor the presence of specific biomarkers found in the wound exudate, such as matrix metalloproteinases (MMPs). In this study, the pSiRM is designed, fabricated, and functionalized using a fluorogenic MMP peptide substrate featuring both a fluorophore and a quencher. The peptide‐functionalized pSiRM is then employed as a fluorescence‐based optical biosensor for MMPs. Active MMPs recognize and cleave the peptide sequence of the substrate, producing an immobilized peptide fragment carrying the fluorophore. The fluorescence intensity of the fluorophore embedded within the pSiRM matrix is enhanced by the photonic structure of the pSiRM compared to other pSi photonic structures. This fluorescence enhancement translates into high sensitivity, enabling detection of MMP‐1 at a limit of detection as low as 7.5 × 10−19 m after only 15 min incubation time. Finally, the biosensor also allows the detection and quantification of the concentration of MMPs in human wound fluid.
Porous anodized aluminum oxide (pAAO) is a nanostructured material, which due to its optical properties lends itself to the design of optical biosensors where interactions in the pores of this material are transduced into interferometric reflectance shifts. In this study, a pAAO-based biosensor was developed as a biosensing platform to detect proteinase K, an enzyme which is a readily available model system for the proteinase produced by Pseudomonas aeruginosa. The pAAO pore walls are decorated by means of the layer-by-layer (LbL) deposition technique using poly(sodium-4-styrenesulfonate) and poly-l-lysine as negatively and positively charged polyelectrolytes, respectively. Interferometric reflectance spectroscopy utilized to observe the optical properties of pAAO during LbL deposition shows that the deposition of the polyelectrolyte onto the pore walls increases the net refractive index, thus red-shifting the effective optical thickness (EOT). Upon incubation with proteinase K, a conspicuous blue shift of the EOT is observed, which is attributed to the destabilization of the LbL film upon enzymatic degradation of the poly-l-lysine components. This result is confirmed by scanning electron microscopy results. Finally, as a proof-of-principle, we demonstrate the ability of the label-free pAAO-based biosensing platform to detect the presence of the proteinase K in human wound fluid, highlighting the potential for detection of bacterial infections in chronic wounds.
An optical biosensor based on the switching of poly(4-vinylphenylboronic acid) (PVPBA) grafted to the pores of porous silicon (pSi) films in response to pH and glucose.
Bacterial wound infections can cause septicemia and lead to limb amputation or death. Therefore, early detection of bacteria is important in chronic wound management. Here, an optical biosensor based on porous silicon resonant microcavity (pSiRM) structure modified with fluorogenic peptide substrate is demonstrated to detect the presence of Sortase A (SrtA), a bacterial enzyme found in the cell membrane protein of Staphylococcus aureus. The combination of fluorescence enhancement effects of the pSiRM architecture with the incorporation of SrtA fluorogenic peptide substrate within the pSi matrix enables the sensing of SrtA with an outstanding limit of detection of 8 × 10−14 m. Modification of the pSiRM structure with microscale spots of two fluorogenic peptide substrates, one specific for SrtA and the other for matrix metalloproteinases, effectively demonstrates the feasibility to perform multiplexed biomarker analysis. The results in this study highlight the potential of the pSiRM sensing platform as a point‐of‐care diagnostic tool for biomarkers of bacterial wound infection.
Matrix metalloproteinases (MMP) are proteolytic enzymes important to wound healing. In non-healing wounds, it has been suggested that MMP levels become dysfunctional, hence it is of great interest to develop sensors to detect MMP biomarkers. This study presents the development of a label-free optical MMP biosensor based on a functionalised porous silicon (pSi) thin film. The biosensor is fabricated by immobilising a peptidomimetic MMP inhibitor in the porous layer using hydrosilylation followed by amide coupling. The binding of MMP to the immobilised inhibitor translates into a change of effective optical thickness over time. We investigated the effect of surface functionalisation on the stability of the pSi surface and evaluated sensing performance. We successfully demonstrated MMP detection in buffer solution and human wound fluid at physiologically relevant concentrations. This biosensor may find application as a point-of-care device that is prognostic of the healing trajectory of chronic wounds.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.