Energetic disorder is crucial to consistently model both absorption and photoluminescence spectra of charge transfer states in organic solar cells.

simple picture, be considered as an electron on the more and a hole on the less electronegative chromophore. The key step in the photogeneration of charges in organic solar cell consists in the separation of this electron-hole pair against their mutual coulomb attraction. In a medium with a dielectric constant of 3.5, the Coulomb energy of opposite point charges with mutual separation of 1 nm is 410 meV. At room temperature, the associated Boltzmann factor for dissociation, expwould thus be about 10 −7 . On other hand, in an efficient solar cell composed of appropriate electron donor and acceptor materials the internal quantum efficiency can be close to 100%, [1] and is only weakly temperature dependent. [2] For example, Gao and co-workers report activation energies for charge separation that are as low as 25 meV for P3HT:PCBM when the film is disordered, and that decrease to 9 meV when the film is better ordered after an annealing step. [2a] Similarly, Kurpiers and co-workers report 23 meV for PCPDTBT:PCBM, i.e., also in the range of thermal energy at room temperature. [2b] How can both facts, i.e., the expected high binding energy of a localized electron-hole pair and the efficient, only weaklyThe high efficiencies reported for organic solar cells and an almost negligible thermal activation measured for the photogeneration of charge carriers have called into question whether photoinduced interfacial charge transfer states are bound by a significant coulomb attraction, and how this can be reconciled with very low activation energies. Here, this question is addressed in a combined experimental and theoretical approach. The interfacial binding energy of a charge-transfer state in a blend of MeLPPP:PCBM is determined by using energy resolved electrochemical impedance spectroscopy and is found to be about 0.5 eV. Temperature-dependent photocurrent measurements on the same films, however, give an activation energy that is about one order of magnitude lower. Using analytical calculations and Monte Carlo simulation the authors illustrate how i) interfacial energetics and ii) transport topology reduce the activation energy required to separate the interfacial electron-hole pair, with about equal contributions from both effects. The activation energy, however, is not reduced by entropy, although entropy increases the overall photodissociation yield.

Organic solar cells (OSCs) have achieved much attention and meanwhile reach efficiencies above 10%. One problem yet to be solved is the lack of long term stability. Crosslinking is presented as a tool to increase the stability of OSCs. A number of materials used for the crosslinking of bulk heterojunction cells are presented. These include the crosslinking of low bandgap polymers used as donors in bulk heterojunction cells, as well as the crosslinking of fullerene acceptors and crosslinking between donor and acceptor. External crosslinkers often based on multifunctional azides are also discussed. In the second part, some work either leading to OSCs with high efficiencies or giving insight into the chemistry and physics of crosslinking are highlighted. The diffusion of low molar mass fullerenes in a crosslinked matrix of a conjugated polymer and the influence of crosslinking on the carrier mobility is discussed. Finally, the use of crosslinking to make stable interlayers and the solution processing of multilayer OSCs are discussed in addition to presentation of a novel approach to stabilize nanoimprinted patterns for OSCs by crosslinking.

While it has been argued that field‐dependent geminate pair recombination (GR) is important, this process is often disregarded when analyzing the recombination kinetics in bulk heterojunction organic solar cells (OSCs). To differentiate between the contributions of GR and nongeminate recombination (NGR) the authors study bilayer OSCs using either a PCDTBT‐type polymer layer with a thickness from 14 to 66 nm or a 60 nm thick p‐DTS(FBTTh2)2 layer as donor material and C60 as acceptor. The authors measure JV‐characteristics as a function of intensity and charge‐extraction‐by‐linearly‐increasing‐voltage‐type hole mobilities. The experiments have been complemented by Monte Carlo simulations. The authors find that fill factor (FF) decreases with increasing donor layer thickness (Lp) even at the lowest light intensities where geminate recombination dominates. The authors interpret this in terms of thickness dependent back diffusion of holes toward their siblings at the donor–acceptor interface that are already beyond the Langevin capture sphere rather than to charge accumulation at the donor–acceptor interface. This effect is absent in the p‐DTS(FBTTh2)2 diode in which the hole mobility is by two orders of magnitude higher. At higher light intensities, NGR occurs as evidenced by the evolution of s‐shape of the JV‐curves and the concomitant additional decrease of the FF with increasing layer thickness.

We discuss whether electron transfer from a photoexcited polymer donor to a fullerene acceptor in an organic solar cell is tractable in terms of Marcus theory, and whether the driving force ΔG 0 is crucial in this process. Considering that Marcus rates are presumed to be thermally activated, we measured the appearance time of the polaron (i.e., the radical-cation) signal between 12 and 295 K for the representative donor polymers PTB7, PCPDTBT, and Me-LPPP in a blend with PCBM as acceptor. In all cases, the dissociation process was completed within the temporal resolution of our experimental setup (220–400 fs), suggesting that the charge transfer is independent of ΔG 0. We find that for the PCPDTBT:PCBM (ΔG 0 ≈ −0.2 eV) and PTB7:PCBM (ΔG 0 ≈ −0.3 eV) the data is mathematically consistent with Marcus theory, yet the condition of thermal equilibrium is not satisfied. For MeLPPP:PCBM, for which electron transfer occurs in the inverted regime (ΔG 0 ≈ −1.1 eV), the dissociation rate is inconsistent with Marcus theory but formally tractable using the Marcus–Levich–Jortner tunneling formalism which also requires thermal equilibrium. This is inconsistent with the short transfer times we observed and implies that coherent effects need to be considered. Our results imply that any dependence of the total yield of the photogeneration process must be ascribed to the secondary escape of the initially generated charge transfer state from its Coulomb potential.

We use bilayer devices with a series of three fullerene acceptors differing in order and intermolecular coupling to systematically explore the influence of electron delocalization in the acceptor phase on the dissociation efficiency of charge transfer states. Structural information from GIWAXS measurements is combined with the results of optical and electrical characterization as well as theoretical modeling.Our results indicate that an increase in CT-dissociation efficiency is directly coupled to an enhancement in electron delocalization that is particularly prominent for C 60 which forms crystalline domains. Therefore, our results substantiate the concept of delocalization of electrons taking a positive role in the charge separation process, and of acceptor crystallinity being crucial in this respect.

Electrospun fibres from the non-conjugated polymer polyacrylonitrile are aligned by heat-stretching. These aligned fibers emit polarized blue fluorescence and green phosphorescence.

Here, we report the synthesis, optical properties, and solid-state packing of monodisperse oligomers of diketopyrrolopyrrole (DPP) up to five repeating units. The optical properties of DPP oligomers in solution and the solid state were investigated by a combination of steady-state and transient spectroscopy. Transient absorption spectroscopy and time-correlated single photon counting (TCSPC) measurements show that the fluorescence lifetime decreases with an increase in the oligomer size from monomer to trimer, thereby reaching saturation for pentameric DPP oligomers. The solid-state packing and crystallinity were probed by using advanced techniques, which included grazing incidence small-angle X-ray scattering (GISAXS) and X-ray diffraction (XRD) to elucidate the structure-property trend. Collectively, our chain-length dependent studies establish the fundamental correlation between the structure and property and provide a comprehensive understanding of the solid-state properties in DPP-DPP based conjugated systems.