Carbon aerogels and Cr-, Fe-, Co-, and Ni-containing carbon aerogels were obtained by pyrolysis, at temperatures between 500 and 1800 °C, of the corresponding aerogels prepared by the sol−gel method from polymerization of resorcinol with formaldehyde. All samples were characterized by mercury porosimetry, nitrogen adsorption, X-ray diffraction (XRD), high-resolution transmission electron microscopy (HRTEM), and Raman spectroscopy. Results obtained show that carbon aerogels are, essentially, macroporous materials that maintain large pore volumes even after pyrolysis at 1800 °C. For pyrolysis at temperatures higher than 1000 °C, the presence of the transition metals produced graphitized areas with three-dimensional stacking order, as shown by HRTEM, XRD, and Raman spectroscopy. HRTEM also showed that the metal−carbon containing aerogels were formed by polyhedral structures. Cr and Fe seem to be the best catalysts for graphitization of carbon aerogels.

No abstract

No abstract

Abstract-An activated carbon obtained from olive stones and with very low ash content (0.10%) was treated with either HCI, HF or HNO,. The changes in surface area and porosity resulting from the acid treatments were studied by N, and CO, adsorption at 77 and 273 K, respectively and by mercury porosimetry. The changes in surface chemistry were studied by temperature-programmed desorption and Fourier transformed infrared spectroscopy. The treatments with HCl yielded activated carbons on which some chlorine remained chemisorbed, whereas the HF treatment did not fix any fluorine. Due to this, the HCI treatment had a slight effect on the microporosity of the samples. Moreover, the HF treatment increased the amount of CO-evolving surface groups. The treatment with HNO, destroyed the pore walls to a large extent, fixing a large amount of oxygen surface groups. The nature and structure of the CO-and CO,-evolving groups will be discussed in detail. 0 1997 Elsevier Science Ltd All rights reserved

No abstract

No abstract

No abstract

No abstract