The hot pressing process for fabricating membrane electrode assemblies (MEAs) has been widely adopted, yet little is known of its effects on the microstructural properties of the different components of the MEA. In particular, the interaction of the electrolyte, electrode and gas diffusion layer (GDL) due to lamination is difficult to probe as conventional imaging techniques cannot access the internal structure of the MEA. Here, a novel approach is used, which combines characterisation of hot-pressed membrane electrode assemblies using X-ray computed tomography, thermogravimetric analysis, differential scanning calorimetry and atomic force microscopy, with electrochemical performance measurements from polarisation curves and high-frequency impedance spectroscopy. Membrane electrode assemblies hot pressed at 100 o C, 130 o C and 170 o C reveal significant differences in microstructure, which has a consequence for the performance. When hot pressed at 100 o C, which is lower than the glass transition temperature of Nafion (123 o C), the catalyst only partially bonds with the Nafion membrane, leading to increased Ohmic resistance. At 170 o C, the Nafion membrane intrudes into the electrode, forming pinholes, degrading the catalyst layer and filling pores in the GDL. Finally, at 130 o C, the interfacial contact is optimum, with similar roughness factor between the catalyst and Nafion membrane surface, indicating effective lamination of layers.

The permeability of shales is important, because it controls where oil and gas resources can migrate to and where in the Earth hydrocarbons are ultimately stored. Shales have a well-known anisotropic directional permeability that is inherited from the depositional layering of sedimentary laminations, where the highest permeability is measured parallel to laminations and the lowest permeability is perpendicular to laminations. We combine state of the art laboratory permeability experiments with high-resolution X-ray computed tomography and for the first time can quantify the three-dimensional interconnected pathways through a rock that define the anisotropic behaviour of shales. Experiments record a physical anisotropy in permeability of one to two orders of magnitude. Two- and three-dimensional analyses of micro- and nano-scale X-ray computed tomography illuminate the interconnected pathways through the porous/permeable phases in shales. The tortuosity factor quantifies the apparent decrease in diffusive transport resulting from convolutions of the flow paths through porous media and predicts that the directional anisotropy is fundamentally controlled by the bulk rock mineral geometry. Understanding the mineral-scale control on permeability will allow for better estimations of the extent of recoverable reserves in shale gas plays globally.

Graphite is the most commonly used anode material in commercial lithium-ion batteries (LiBs). Understanding the mechanisms driving the dimensional changes of graphite can pave the way to methods for inhibiting degradation pathways and possibly predict electrochemical performance loss. In this study, correlative microscopy tools were used alongside electrochemical dilatometry (ECD) to provide new insights into the dimensional changes during galvanostatic cycling. X-ray computed tomography (CT) provided a morphological perspective of the cycled electrode so that the effects of dilation and contraction on effective diffusivity and electrode pore phase volume fraction could be examined. During the first cycle, the graphite electrode underwent thickness changes close to 9% after lithiation and, moreover, it did not return to its initial thickness after subsequent delithiation. The irreversible dilation increased over subsequent cycles. It is suggested the primary reason for this dilation is electrode delamination. This is supported by the finding that the electrode porosity remained mostly unchanged during cycling, as revealed by X-ray CT.

Imaging compound action potentials (CAPs) in peripheral nerves could help avoid side effects in neuromodulation by selective stimulation of identified fascicles. Existing methods have low resolution, limited imaging depth, or are invasive. Fast neural electrical impedance tomography (EIT) allows fascicular CAP imaging with a resolution of <200 µm, <1 ms using a non-penetrating flexible nerve cuff electrode array. Here, we validate EIT imaging in rat sciatic nerve by comparison to micro-computed tomography (microCT) and histology with fluorescent dextran tracers. With EIT, there are reproducible localized changes in tissue impedance in response to stimulation of individual fascicles (tibial, peroneal and sural). The reconstructed EIT images correspond to microCT scans and histology, with significant separation between the fascicles (p < 0.01). The mean fascicle position is identified with an accuracy of 6% of nerve diameter. This suggests fast neural EIT can reliably image the functional fascicular anatomy of the nerves and so aid selective neuromodulation.

SARS-CoV-2 may spread through respiratory droplets released by infected individuals. The viruses are transmitted in moist droplets which cause coronavirus disease. Many countries have mandated the wearing of face masks, to various extents. However, the efficacy of masks is yet to be well rationalised given the limited microstructure information. Here, three common face masks and associated air permeations were revealed by coupling X-ray tomographic imaging and infrared thermal imaging techniques. Quantitative parameters have been extracted from the 3D images. Also, image-based modelling was performed to simulate the permeability to show how droplets pass through the porous structure. Our results show that the N95 mask has the smallest average pore diameter (~30 µm) and the densest nanoscale fibres which provides superior droplet filtration among all cases. Modifications to the N95 masks are proposed to develop the next generation mask with higher efficacy and better breathability.

This method for virtually unrolling the jelly roll of a lithium ion cell using X-ray CT highlights the predictability of macro deformations formed while cycling. The failure is shown to propagate from nucleation points present since production.

No abstract

Highlights d A central organ of proprioception exists in the spinal cord d Piezo2-expressing mechanosensitive neurons sense lateral bending of spinal cord d These are inhibitory commissural neurons targeting the locomotor rhythm generator d Intraspinal proprioceptive feedback aligns movements with motor commands