Abstract. The success of geological carbon storage depends on the assurance of permanent containment for injected carbon dioxide (CO2) in the storage formation at depth. One of the critical elements of the safekeeping of CO2 is the sealing capacity of the caprock overlying the storage formation despite faults and/or fractures, which may occur in it. In this work, we present an ongoing injection experiment performed in a fault hosted in clay at the Mont Terri underground rock laboratory (NW Switzerland). The experiment aims to improve our understanding of the main physical and chemical mechanisms controlling (i) the migration of CO2 through a fault damage zone, (ii) the interaction of the CO2 with the neighboring intact rock, and (iii) the impact of the injection on the transmissivity in the fault. To this end, we inject CO2-saturated saline water in the top of a 3 m thick fault in the Opalinus Clay, a clay formation that is a good analog of common caprock for CO2 storage at depth. The mobility of the CO2 within the fault is studied at the decameter scale by using a comprehensive monitoring system. Our experiment aims to close the knowledge gap between laboratory and reservoir scales. Therefore, an important aspect of the experiment is the decameter scale and the prolonged duration of observations over many months. We collect observations and data from a wide range of monitoring systems, such as a seismic network, pressure temperature and electrical conductivity sensors, fiber optics, extensometers, and an in situ mass spectrometer for dissolved gas monitoring. The observations are complemented by laboratory data on collected fluids and rock samples. Here we show the details of the experimental concept and installed instrumentation, as well as the first results of the preliminary characterization. An analysis of borehole logging allows for identifying potential hydraulic transmissive structures within the fault zone. A preliminary analysis of the injection tests helped estimate the transmissivity of such structures within the fault zone and the pressure required to mechanically open such features. The preliminary tests did not record any induced microseismic events. Active seismic tomography enabled sharp imaging the fault zone.

Abstract. Ice-wedge polygons are common Arctic landforms. The future of these landforms in a warming climate depends on the bidirectional feedback between the rate of ice-wedge degradation and changes in hydrological characteristics. This work aims to better understand the relative roles of vertical and horizontal water fluxes in the subsurface of polygonal landscapes, providing new insights and data to test and calibrate hydrological models. Field-scale investigations were conducted at an intensively instrumented location on the Barrow Environmental Observatory (BEO) near Utqiaġvik, AK, USA. Using a conservative tracer, we examined controls of microtopography and the frost table on subsurface flow and transport within a low-centered and a high-centered polygon. Bromide tracer was applied at both polygons in July 2015 and transport was monitored through two thaw seasons. Sampler arrays placed in polygon centers, rims, and troughs were used to monitor tracer concentrations. In both polygons, the tracer first infiltrated vertically until encountering the frost table and was then transported horizontally. Horizontal flow occurred in more locations and at higher velocities in the low-centered polygon than in the high-centered polygon. Preferential flow, influenced by frost table topography, was significant between polygon centers and troughs. Estimates of horizontal hydraulic conductivity were within the range of previous estimates of vertical conductivity, highlighting the importance of horizontal flow in these systems. This work forms a basis for understanding complexity of flow in polygonal landscapes.

Improving understanding of Arctic ecosystem climate feedback and parameterization of models that simulate freeze-thaw dynamics require advances in quantifying soil and snow properties. Due to the significant spatiotemporal variability of soil properties and the limited information provided by point-scale measurements (e.g., cores), geophysical methods hold potential for improving soil and permafrost characterization. In this study, we evaluate the use of a ground-penetrating radar (GPR) to estimate thaw layer thickness, snow depth, and ice-wedge characteristics in an icewedge-dominated tundra region near Barrow, AK, USA. To this end, we analyze GPR and point-scale measurements collected along several parallel transects at the end of the growing season and the end of frozen season. In addition, we compare the structural information extracted from the GPR data with electrical resistivity tomography (ERT) information about ice-wedge characteristics. Our study generally highlights the value of GPR data collected in the frozen season, when conditions lead to the improved GPR signal-to-noise ratio, facilitate data acquisition, and reduce acquisitionrelated ecosystem disturbance relative to growing season. We document for the first time that GPR data collected during the frozen season can provide reliable estimates of active layer thickness and geometry of ice wedges. We find that the ice-wedge geometry extracted from GPR data collected during the frozen season is consistent with ERT data, and that GPR data can be used to constrain the ERT inversion. Consistent with recent studies, we also find that GPR data collected during the frozen season can provide good estimates of snow thickness, and that GPR data collected during the growing season can provide reliable estimate thaw depth. Our quantification of the value of the GPR and ERT data collected during growing and frozen seasons paves the way for coupled inversion of the datasets to improve understanding of permafrost variability. Abstract:Improving understanding of Arctic ecosystem climate feedback and parameterization of models that simulate freeze-thaw dynamics require advances in quantifying soil and snow properties. Due to the significant spatiotemporal variability of soil properties and the limited information provided by point-scale measurements (e.g., cores), geophysical methods hold potential for improving soil and permafrost characterization. In this study, we evaluate the use of a ground-penetrating radar (GPR) to estimate thaw layer thickness, snow depth, and ice-wedge characteristics in an icewedge-dominated tundra region near Barrow, AK, USA. To this end, we analyze GPR and point-scale measurements collected along several parallel transects at the end of the growing season and the end of frozen season. In addition, we compare the structural information extracted from the GPR data with electrical resistivity tomography (ERT) information about ice-wedge characteristics. Our study generally highlights the value of GPR data collected in the frozen season, whe...

Abstract. The success of geological carbon storage depends on the assurance of a permanent confinement of the injected CO2 in the storage formation at depth. One of the critical elements of the safekeeping of CO2 is the sealing capacity of the caprock overlying the storage formation, despite faults and/or fractures, which may occur in it. In this work, we present an ongoing injection experiment performed in a fault hosted in clay at the Mont Terri underground rock laboratory (NW Switzerland). The experiment aims at improving our understanding on the main physical and chemical mechanisms controlling i) the migration of CO2 through a fault damage zone, ii) the interaction of the CO2 with the neighbouring intact rock, and iii) the impact of the injection on the transmissivity in the fault. To this end, we inject a CO2-saturated saline water in the top of a 3 m think fault in the Opalinus Clay, a clay formation that is a good analogue of common caprock for CO2 storage at depth. The mobility of the CO2 within the fault is studied at decameter scale, by using a comprehensive monitoring system. Our experiment aims to the closing of the knowledge gap between laboratory and reservoir scales. Therefore, an important aspect of the experiment is the decameter scale and the prolonged duration of observations over many months. We collect observations and data from a wide range of monitoring systems, such as a seismic network, pressure temperature and electrical conductivity sensors, fiber optics, extensometers, and an in situ mass spectrometer for dissolved gas monitoring. The observations are complemented by laboratory data on collected fluids and rock samples. Here we show the details of the experimental concept and installed instrumentation, as well as the first results of the preliminary characterization. Analysis of borehole logging allow identifying potential hydraulic transmissive structures within the fault zone. A preliminary analysis of the injection tests helped estimating the transmissivity of such structures within the fault zone, as well as the pressure required to mechanically open such features. The preliminary tests did not record any induced microseismic events. Active seismic tomography enabled a sharp imaging the fault zone.

We provide direct observations of the three‐dimensional displacements of a fluid‐driven fracture during water injections in a borehole at ∼1.5 km depth in the crystalline rock at the Sanford Underground Research Facility (USA). Micro‐shearing of the borehole initiates on a foliation plane at 61% of the minimum principal stress σ3. As the fluid pressure increases further up to 112% of σ3, borehole axial and radial displacements increase with injection time highlighting the opening and sliding of a new hydrofracture growing ∼10 m away from the borehole, in accordance with the ambient normal stress regime and in alignment with the microseismicity. Our study reveals how important it is to consider monitoring zonal deformation in conjunction with pressure and flow to better manage the complex hydromechanical evolution of the growing fracture.