Near-infrared emission from semiconducting single-walled carbon nanotubes (SWNTs) usually results from radiative relaxation of excitons. By binding an additional electron or hole through chemical or electrochemical doping, charged three-body excitons, so-called trions, are created that emit light at lower energies. The energy difference is large enough to observe weak trion photoluminescence from doped SWNTs even at room temperature. Here, we demonstrate strong trion electroluminescence from electrolyte-gated, light-emitting SWNT transistors with three different polymer-sorted carbon nanotube species, namely, (6,5), (7,5) and (10,5). The red-shifted trion emission is equal to or even stronger than the exciton emission, which is attributed to the high charge carrier density in the transistor channel. The possibility of trions as a radiative relaxation pathway for triplets and dark excitons that are formed in large numbers by electron-hole recombination is discussed. The ratio of trion to exciton emission can be tuned by the applied voltages, enabling voltage-controlled near-infrared light sources with narrow line widths that are solution-processable and operate at low voltages (<3 V).

The selective dispersion of single-walled carbon nanotube species (n,m) with conjugated polymers such as poly(9,9-dioctylfluorene) (PFO) and poly(9,9-dioctylfluorene-co-benzothiadiazole) (F8BT) in organic solvents depends not only on the type of solvent but also on the molecular weight of the polymer. We find an increasing amount of nanotubes and altered selectivities for dispersions with higher molecular weight polymers. Including the effects of different aromatic solvents, we propose that solution viscosity is one of the factors influencing the apparent selectivity by changing the reaggregation rate of the single-walled carbon nanotubes (SWNT). The type of solvent, polymer molecular weight, concentration, and viscosity should thus be taken into account when screening for new polymers for selective SWNT dispersion.

We investigate the influence of small amounts of semiconducting single-walled carbon nanotubes (SWNTs) dispersed in polyfluorenes such as poly(9,9-di-n-octylfluorene-alt-benzothiadiazole (F8BT) and poly(9,9-dioctylfluorene) (F8) on device characteristics of bottom contact/top gate ambipolar light-emitting field-effect transistors (LEFETs) based on these conjugated polymers. We find that the presence of SWNTs within the semiconducting layer at concentrations below the percolation limit significantly increases both hole and electron injection, even for a large band gap semiconductor like F8, without leading to significant luminescence quenching of the conjugated polymer. As a result of the reduced contact resistance and lower threshold voltages, larger ambipolar currents and thus brighter light emission are observed. We examine possible mechanisms of this effect such as energy level alignment, reduced bulk resistance above the contacts, and field-enhanced injection at the nanotube tips. The observed ambipolar injection improvement is applicable to most conjugated polymers in staggered transistor configurations or similar organic electronic devices where injection barriers are an issue.

We demonstrate random network single-walled carbon nanotube (SWNT) field-effect transistors (FETs) in bottom contact/top gate geometry with only five different semiconducting nanotube species that were selected by dispersion with poly(9,9-dioctylfluorene) in toluene. These FETs are highly ambipolar with balanced hole and electron mobilities and emit near-infrared light with narrow peak widths (<40 meV) and good efficiency. We spatially resolve the electroluminescence from the channel region during a gate voltage sweep and can thus trace charge transport paths through the SWNT thin film. A shift of emission intensity to large diameter nanotubes and gate-voltage-dependent photoluminescence quenching of the different nanotube species indicates excitation transfer within the network and preferential charge accumulation on small band gap nanotubes. Apart from applications as near-infrared emitters with selectable emission wavelengths and narrow line widths, these devices will help to understand and model charge transport in realistic carbon nanotube networks.

No abstract