Ocimum basilicum var. purpurascens leaves are a rich source of bioactive compounds with antimicrobial activity, which could be considered as an excellent ingredient for the food industry.

Heat-Assisted Extraction (HAE) was used for the optimized production of an extract rich in anthocyanin compounds from Ocimum basilicum var. purpurascens leaves. The optimization was performed using the response surface methodology employing a central composite experimental design with five-levels for each of the assessed variables. The independent variables studied were the extraction time (t, 20–120 min), temperature (T, 25–85 °C), and solvent (S, 0–100% of ethanol, v/v). Anthocyanin compounds were analysed by HPLC-DAD-ESI/MS and the extraction yields were used as response variables. Theoretical models were developed for the obtained experimental data, then the models were validated by a selected number of statistical tests, and finally, those models were used in the prediction and optimization steps. The optimal HAE conditions for the extraction of anthocyanin compounds were: t = 65.37 ± 3.62 min, T = 85.00 ± 1.17 °C and S = 62.50 ± 4.24%, and originated 114.74 ± 0.58 TA mg/g of extract. This study highlighted the red rubin basil leaves as a promising natural matrix to extract pigmented compounds, using green solvents and reduced extraction times. The extract rich in anthocyanins also showed antimicrobial and anti-proliferative properties against four human tumor cell lines, without any toxicity on a primary porcine liver cell line.

In the present work, sage (Salvia officinalis L.) and basil (Ocimum basilicum L.) were exploited for their preservative purposes, as viable alternatives to artificial ones. The ultrasound-assisted extraction (UAE) of bioactive compounds was pre-optimized using factorial screening analysis, prior to applying response surface methodology (RSM). The obtained extracts were characterized in terms of phenolic compounds by high-performance liquid chromatography coupled to photodiode array detector and mass spectrometer HPLC-DAD-ESI/MS and bioactivities, namely the antioxidant, antimicrobial and cytotoxic potential. In addition, the most promising extracts were incorporated into yogurts, that were further screened for nutritional and physico-chemical properties and microbial load, over a shelf life of 14 days. According to the obtained results, the solvent percentage is the most relevant factor for obtaining rosmarinic acid-rich extract, followed by the extraction time and ultrasonic power. For the antioxidant and antimicrobial activity, sage showed the best result for both analysis and none of the two plant extracts were hepatotoxic. Finally, both extracts did not show changes in the physicochemical and nutritional characteristics of the yogurts and did not interfere with the growth of lactic acid bacteria, an important microorganism during yogurt fermentation. These results highlight the high potential of sage and basil as natural preservatives.

The production of citrus juice generates a large quantity of by-products, which are often discarded or used for animal feed. However, several studies have shown its richness in valuable compounds, namely organic acids. Thus, this work intended to valorize orange and lime peels as renewable sources of citric acid. An experimental design combining five levels of the independent variables time (2–45 min), ultrasonic power (50–500 W), and ethanol proportion (0–100%) was implemented and response surface methodology (RSM) was applied to optimize the extraction process. The UPLC-PDA analysis showed that orange peel presented a higher citric acid content than lime. For lime and orange peels, the extraction yield was maximized by sonicating at low power for 5.8 or 35.5 min, using a low ethanol proportion or only water as a solvent, respectively. Overall, optimal UAE conditions were defined for the sustainable extraction of citric acid from citrus by-products, thus contributing to its valorization and upcycling into natural food ingredients.