The behavior of 6-propionyl-2-dimethylaminonaphthalene (PRODAN) was studied in homogeneous media and in large unilamellar vesicles (LUVs) of the phospholipid 1,2-di-oleoyl-sn-glycero-3-phosphatidylcholine (DOPC), using absorption, emission, depolarization, and time-resolved spectroscopies. In homogeneous media, the Kamlet and Taft solvatochromic comparison method quantified solute-solvent interactions from the absorption and emission PRODAN bands. These studies demonstrate that the absorption band is sensitive to the polarity-polarizability (pi) and the hydrogen bond donor ability (alpha) parameters of the media. PRODAN in the excited state is even more sensitive to these parameters and to the hydrogen bond acceptor ability (beta) of the media. The transition energy (expressed in kcal/mol) for both absorption and emission bands gives a linear correlation with the well-known polarity parameter E(T30). The results from the absorption and emission bands also reveal that PRODAN aggregates in water. The monomer has two fluorescence lifetimes, 2.27 and 0.65 ns, while the aggregate has a lifetime of 14.6 ns. Using steady-state anisotropy measurements, the calculated volumes of the aggregate and the monomer are 5590 and 222 mL mol(-1), respectively. In DOPC LUVs, PRODAN undergoes a partition process between the water bulk and the DOPC bilayer. We show that the partition constant (K(p)) value is large enough that only at [DOPC] below 0.15 mg/mL PRODAN in water can be detected. PRODAN dissolved in LUVs at [DOPC] > 1 mg/mL exists completely incorporated in its monomer form and senses two different microenvironments within the bilayer: a polar region in the interface near the water and a less polar and also less viscous environment, between the phospholipid tails. These environments were characterized by their fluorescence lifetimes (tau), showing that PRODAN in the polar microenvironment has a tau value of approximately 4 ns while in the less polar region gives a value of 1.2 ns. Moreover, this probe also senses the micropolarity of these two different regions of the bilayer and yields values similar to that of methanol and tetrahydrofuran.

Reverse micelles (RMs) are very good nanoreactors because they can create a unique microenvironment for carrying out a variety of chemical and biochemical reactions. The aim of the present work is to determine the influence of different RM interfaces on the hydrolysis of 2-naphthyl acetate (2-NA) by alpha-chymotrypsin (alpha-CT). The reaction was studied in water/benzyl-n-hexadecyldimethylammonium chloride (BHDC)/benzene RMs and, its efficiency compared with that observed in pure water and in sodium 1,4-bis-2-ethylhexylsulfosuccinate (AOT) RMs. Thus, the hydrolysis rates of 2-NA catalyzed by alpha-CT were determined by spectroscopic measurements. In addition, the method used allows the joint evaluation of the substrate partition constant K(p) between the organic and the micellar pseudophase and the kinetic parameters: catalytic rate constant k(cat), and the Michaelis constant K(M) of the enzymatic reaction. The effect of the surfactant concentration on the kinetics parameters was determined at constant W(0)=[H(2)O]/[surfactant], and the variation of W(0) with surfactant constant concentration was investigated. The results show that the classical Michaelis-Menten mechanism is valid for alpha-CT in all of the RMs systems studied and that the reaction takes place at both RM interfaces. Moreover, the catalytic efficiency values k(cat)/K(M) obtained in the RMs systems are higher than that reported in water. Furthermore, there is a remarkable increase in alpha-CT efficiency in the cationic RMs in comparison with the anionic system, presumably due to the unique water properties found in these confined media. The results show that in cationic RMs the hydrogen-bond donor capacity of water is enhanced due to its interaction with the cationic interface. Hence, entrapped water can be converted into "super-water" for the enzymatic reaction studied in this work.

Catanionic surfactants: the synthesis of a new surfactant ionic liquid with unique properties is described. The formation of reverse micelles in benzene and large unilamellar vesicles, formed spontaneously without the help of any mechanical of chemistry methods, in water is demonstrated by using dynamic light scattering and small-angle X-ray scattering techniques.

No abstract

6-Propionyl-2-(N,N-dimethyl)aminonaphtahalene, PRODAN, is widely used as a fluorescent molecular probe due to its significant Stokes shift in polar solvents. It is an aromatic compound with intramolecular charge-transfer (ICT) states which can be particularly useful as sensors. In this work, we performed absorption, steady-state, time-resolved fluorescence (TRES), and time-resolved area normalized emission (TRANES) spectroscopies on PRODAN dissolved in nonaqueous reverse micelles. The reverse micelles are composed of polar solvents/sodium 1,4-bis-2-ethylhexylsulfosuccinate (AOT)/n-heptane. Sequestered polar solvents included ethylene glycol (EG), propylene glycol (PG), glycerol (GY), formamide (FA), dimethylformamide (DMF), and dimethylacetamide (DMA). The experiments were performed with varying surfactant concentrations at a fixed molar ratio W(S) = [polar solvent]/[AOT]. In every reverse micelle studied, the results show that PRODAN undergoes a partition process between the external solvent and the reverse micelle interface. The partition constants, K(p), are quantified from the changes in the PRODAN emission and/or absorption spectra with the surfactant concentration. The K(p) values depend strongly on the encapsulated polar solvent and correlate quite well with the AOT reverse micelle interface's zones where PRODAN can exist and emits. Thus, the partition toward the reverse micelle interface is strongly favored in DMF and DMA containing micelles where the PRODAN emission comes only from an ICT state. For GY/AOT reverse micelles, the K(p) value is the lowest and only emission from the local excited (LE) state is observed. On the other hand, for EG/AOT, PG/AOT, and water/AOT reverse micelles, the K(p) values are practically the same and emission from both states (LE and ICT) is simultaneously detected. We show here that it is possible to control the PRODAN state emission by simply changing the properties of the AOT reverse micelle interfaces by choosing the appropriate polar solvent to make the reverse micelle media. Indeed, we present experimental evidence with the answer to the long time question about from which state does PRODAN emit, a process that can be controlled using the unique reverse micelle interfaces properties.