No abstract

No abstract

No abstract

With the potential to map mechanical properties of heterogeneous materials on a micrometer scale, there is growing interest in nanoindentation as a materials characterization technique. However, nanoindentation has been developed primarily for characterization of hard, elasto-plastic materials, and the technique has not been validated for very soft materials with moduli less than 5 MPa. The current study attempted to use nanoindentation to characterize the elastic moduli of soft, elastomeric polydimethylsiloxane (PDMS) samples (with different degrees of crosslinking) and determine the effects of adhesion on these measurements using adhesion contact mechanics models. Results indicate that nanoindentation was able to differentiate between elastic moduli on the order of hundreds of kilo-Pascals. Moreover, calculations using the classical Hertz contact model for dry and aqueous environment gave higher elastic modulus values when compared to those obtained from unconfined compression testing. These data seem to suggest that consideration of the adhesion energy at the tip-sample interface is a significantly important parameter and needs to be taken into account for consistent elastic modulus determination of soft materials by nanoindentation.

No abstract

Gelatin fibers were prepared by electrospinning of gelatin/acetic acid/water ternary mixtures with the aim of studying the feasibility of fabricating gelatin nanofiber mats at room temperature using an alternative benign solvent by significantly reducing the acetic acid concentration. The results showed that gelatin nanofibers can be optimally electrospun with low acetic acid concentration (25% v/v) combined with gelatin concentrations higher than 300 mg/ml. Both gelatin solutions and electrospun gelatin mats (prepared with different acetic acid aqueous solutions) were analyzed by FTIR and DSC techniques in order to determine the chemical and structure changes of the polymer. The electrospun gelatin mats fabricated from solutions with low acetic acid content showed some advantages as the maintenance of the decomposition temperature of the pure gelatin (~230ºC) and the reduction of the acid content on electrospun mats, which allowed to reach a cell viability upper than 90% (analyzed by cell viability test using human dermal fibroblast and embryonic kidney cells). This study has also analyzed the influence of gelatin and acetic acid concentration both on the solution viscosity and the electrospun fiber diameter, obtaining a clear relationship between these parameters.

No abstract

No abstract