Carbon materials and nanomaterials are of great interest for biological applications such as implantable devices and nanoparticle vectors, however, to realize their potential it is critical to control formation and composition of the protein corona in biological media. In this work, protein adsorption studies were carried out at carbon surfaces functionalized with aryldiazonium layers bearing mono- and di-saccharide glycosides. Surface IR reflectance absorption spectroscopy and quartz crystal microbalance were used to study adsorption of albumin, lysozyme and fibrinogen. Protein adsorption was found to decrease by 30–90% with respect to bare carbon surfaces; notably, enhanced rejection was observed in the case of the tested di-saccharide vs. simple mono-saccharides for near-physiological protein concentration values. ζ-potential measurements revealed that aryldiazonium chemistry results in the immobilization of phenylglycosides without a change in surface charge density, which is known to be important for protein adsorption. Multisolvent contact angle measurements were used to calculate surface free energy and acid-base polar components of bare and modified surfaces based on the van Oss-Chaudhury-Good model: results indicate that protein resistance in these phenylglycoside layers correlates positively with wetting behavior and Lewis basicity.

Modification of carbon materials via incorporation of nitrogen has received much attention in recent years due to their performance as electrodes in applications ranging from electroanalysis to electrocatalysis for energy storage technologies. In this work we synthesized nitrogen-incorporated amorphous carbon thin film electrodes (a-C:N) with different degrees of nitrogenation via magnetron sputtering. Electrodes were characterized using a combination of spectroscopic and electrochemical methods, including X-ray photoelectron spectroscopy, ellipsometry, voltammetry, and impedance spectroscopy. Results indicate that low levels of nitrogenation yield carbon materials with narrow optical gaps and semimetallic character. These materials displayed fast electron-transfer kinetics to hexammine ruthenium­(II)/(III), an outer-sphere redox couple that is sensitive to electronic properties near the Fermi level in the electrode material. Increasing levels of nitrogenation first decrease the metallic character of the electrodes, increase the impedance to charge transfer and, ultimately, yield materials with optical and electrochemical properties consistent with disordered cluster aggregates rather than amorphous solids. A positive correlation was found between the resistance to charge transfer and the optical gap when using the outer-sphere redox couple. Interestingly, the use of ferrocyanide as a surface-sensitive redox probe resulted in a monotonic increase of the impedance to charge transfer vs nitrogen content. This result suggests that surface chemical effects can dominate the electrochemical response, even when nitrogenation results in enhanced metallic character in carbon electrodes.

Carbon materials are widely used in a range of applications from biomaterials to sensing and electronics. Many of these applications rely on the ability to control carbon/water interfacial properties, in particular, surface charge density. This work reports a study of the electrokinetic properties of amorphous carbon thin films as a function of pH and surface chemistry. Surface ζpotential (SZP) and isoelectric point were determined using the tracer particle method. Initially, the use of sulfonated and amine-terminated latex bead suspensions as tracer particles for the determination of SZP of reference polymer surfaces was validated. The tracer particle method was then applied to the determination of SZP and isoelectric point of macroscopic carbon surfaces with different surface chemistry. Highly graphitic and sp 3 -rich hydrogenated carbon surfaces were found to display negative SZP, as expected for hydrophobic surfaces. The isoelectric point of the most highly graphitic surface was found to be pH iso = 3.7. Surface oxidation of these films resulted in a decrease of SZP at all pH values and in a downshift of pH iso to values lower than 1.5, consistently with the presence of surface acidic groups arising from oxidation. Results indicate that the specific choice of acid/base chemistry for the tracer particles does not significantly affect either SZP or pH iso determinations. These results show that the tracer particle method in combination with widely available latex beads as tracers can be applied for the determination of carbon SZP as a function of pH.