No abstract

The impact strength of PMMA was enhanced by including E-glass fibers, increasing parallel with the fiber concentration.

Objective: The purpose of the study was to determine the effect of different forms and concentrations (2.5, 3, 4, 5% by volume) of glass fibres (chopped strand mat, continuous and woven) on fatigue resistance of acrylic denture base resin. Material and Methods: The fatigue resistance was measured by applying repeated three-point bending deflection to the specimens, the cycle frequency of 1.05 g and magnitude of deflection of 2.0 mm. The number of loading cycles needed to cause a fracture in the test specimen was considered the fatigue resistance of the specimen. Results: The results of this study revealed that the addition of three different glass fibre forms at all concentrations to acrylic resin did not produce a statistically significant increase in the fatigue resistance (p ‡ 0.05). This study also revealed that there were significant differences (p < 0.05) between glass fibres forms used concerning the effects on the fatigue resistance. Conclusion: This study showed that the woven glass fibres had a definite superiority over the chopped fibres and the continuous fibres in regard to the fatigue resistance of the acrylic denture base resin.

The purpose of this study was to evaluate the effects of four different ratios of silanized mica filler and milled glass fiber on the surface hardness of an acrylic denture tooth material. Acrylic resin disks made of polymethyl methacrylate (PMMA) used in fabrication of denture teeth were used as the control group. Eight test groups were prepared by adding a ratio of 5％, 10％, 15％, or 20％ by weight of silane-treated mica filler or milled glass fibers to the PMMA resin of denture teeth. Surface hardness test was performed for each group. There were statistically significant differences in surface hardness between the control group and 5％, 10％, and 15％ mica-and glass-containing test groups (p<0.05). It was determined that addition of 5％, 10％, and 15％ of silane-treated mica filler or silane-treated milled glass fiber to the PMMA resin of denture teeth resulted in significantly improved surface hardness.

No abstract