Adsorption of Reactive Black 5 and Congo Red from aqueous solution by coffee waste modified with polyethylenimine was investigated. The removal percentages of both dyes increased with amount of polyethyleneimine in the modified adsorbent. Characterization revealed that polyethyleneimine modification improved the adsorbent surface chemistry, while slight improvement of adsorbent textural properties was also observed. The adsorbent’s excellent performance was demonstrated by high removal percentages towards the anionic dyes in most experimental runs. The modelling result showed that anionic dyes adsorption occurred via monolayer adsorption, and chemisorption was the rate-controlling step. The adsorbent possesses higher maximum adsorption capacity towards Reactive Black 5 (77.52 mg/g) than Congo Red (34.36 mg/g), due to the higher number of functional groups in Reactive Black 5 that interact with the adsorbent. This study reveals the potential of adsorbent derived from coffee waste in textile wastewater treatment. Furthermore, surface chemistry modification is proven as an effective strategy to enhance the performance of biowaste-derived adsorbents.

No abstract

Malaysia, as one of the leading palm oil producers in the world faces problems in disposal of oil palm empty fruit bunch (EFB), which can be converted into various value-added products, including adsorbents. This study investigated the adsorption of phenol from its solution using biochar produced from EFB through carbonization. Response Surface Methodology (RSM) with Box-Behnken design was used to investigate the effects of three parameters (temperature, time and heating rate) during carbonization on phenol removal by the biochar produced. This was followed by process optimization based on statistical analysis. The results indicated that the optimized carbonization conditions were; 500 °C for temperature, 10 °C/min of heating rate and 80 min for reaction time, which led to 7.57% of phenol removal. SEM revealed coarse and uneven surface of the biochar surface, with small degree of pore development. Comparison between FTIR spectrum of EFB and biochar revealed the loss of water and hydroxyl compounds from EFB during carbonization. The lack of oxygenated groups (especially carbonyl groups) on the adsorbent surface as well as limited number of pores were the possible reasons leading to low phenol adsorption by biochar, therefore conversion of the biochar to activated carbon was necessary for higher adsorption performance.

No abstract

No abstract