Summary Base isolation has been established as the seismic design approach of choice when it comes to protecting nonstructural contents. However, while this protection technology has been widely shown to reduce seismic demands on attached oscillatory equipment and contents (EC), its effectiveness in controlling the response of freestanding EC that are prone to sliding has not been investigated. This study examines the seismic behavior of sliding EC inside base‐isolated buildings subjected to broadband ground motions. The effect of isolation system properties on the response of sliding EC with various friction coefficients is examined. Two widely used isolation models are considered: viscously damped linear elastic and bilinear. The study finds isolation to be generally effective in reducing seismic demands on sliding EC, but it also exposes certain situations where isolation in fact increases demands on EC, most notably for low friction coefficients and high earthquake intensities. Damping at the isolation level is effective in controlling the EC sliding displacements, although damping over about 20% is found to be superfluous. The study identifies a physically motivated dimensionless intensity measure and engineering demand parameter for sliding equipment in base‐isolated buildings subjected to broadband ground motions. Finally, the paper presents easy‐to‐use design fragility curves and an example that illustrates how to use them. Copyright © 2014 John Wiley & Sons, Ltd.

No abstract

No abstract

Summary This paper presents an experimental investigation on the seismic response of medical equipment supported on wheels and/or casters. Two pieces of equipment were tested: a large ultrasound machine and a cart carrying smaller medical equipment. In the first phase, the resistance of the wheels and casters of the equipment was characterized through a controlled‐displacement procedure on the shake table. In the second phase, an extensive shake table test program was carried out to investigate the seismic response of the equipment. The input signals for the shake table tests included floor motions of a four‐story steel braced‐frame hospital designed to satisfy seismic requirements of a site in the Los Angeles area. The results of 96 shake table tests reported in this study include the seismic performance of the equipment under both unlocked and locked conditions, located on various floor levels of the building. It was observed that engaging the casters' locking mechanism does not necessarily decrease the relative displacement. The displacement response was sensitive to the excitation intensity and the orientation of the equipment with respect to the input excitation. Based on the experimental observations, appropriate structural engineering demand parameters associated with the relative displacement and relative velocity demands of the equipment are proposed and used to develop conditional probability curves. Finally, in an effort to extend the results of this experimental study to similar equipment on wheels/casters, the performance of a simple numerical model in predicting the peak seismic demands is evaluated. Copyright © 2016 John Wiley & Sons, Ltd.

No abstract

No abstract

No abstract

No abstract