No abstract

Highlights► Low temperature microwave hydrothermal method is developed to synthesize MgO nanowires. ► The antibacterial properties of MgO nanowires have been examined. ► This novel method serve a direct route for mass production of MgO nanowires and antibacterial agents.

No abstract

ABSTRACT:The influence of Joule heating treatments and carbon black (CB) on the electrical and thermal behavior of epoxy resin composites is well described in this article. The effect of CB and Joule heating on network structure characteristics, such as shrinkability, interparticle distance between conductive particles, crosslinking density, hardness, thermoelectric power, thermal conductivity, the thermal expansion coefficient, and scanning electron microscopy, of epoxy composites was investigated. The electrical conductivity () of epoxy resin correlated with the volume fraction of CB and Joule heating treatment. increased continuously with increasing CB content, and Joule heating increased the level of , which makes it attractive for electronic utilization. The for fresh and Joule heating samples was recorded during heating-cooling cycles. The conduction mechanism of for epoxy composites was identified. The activation energy and hopping energy for two batches of epoxy as a function of CB content were estimated. The hopping distance, the state density at the Fermi level, and the radius of localized wave function versus CB content were evaluated. The current-voltage-temperature characteristics of fresh and Joule heating samples of epoxy composites were demonstrated. The thermal reliability was tested by means of temperature-time characteristics when certain applied power was on and off for several cycles. The specific heat and amount of heat transfer by radiation and convection were calculated based on the energy balance model for two batches. The results indicate that the Joule heating effect is a very effective and prospective way of enhancing the electrical and thermal stability of epoxy-CB composites for consumer use as heaters and in other electronic areas such as electromagnetic shielding effectiveness.

Recently, there is an increasing interest in electromagnetic interference shielding due to the rapid increase in electromagnetic pollution and the wide use of commercial and military products. Conducting polymer composites were prepared in the presence of epoxy resin and plasticized carbon black (CB). The structural characteristics of the composites were examined by means of scanning electron microscopy, cross linking density, and interparticle distance among conductive particles. The mechanical properties such as Young's modulus, elongation at break, and hardness of the composites were investigated as a function of CB content. The results indicated that CB could improve the composite microstructure. The higher mechanical behavior than green epoxy can be attributed to the interaction between CB particles and epoxy resin. The conductivity, mobility carriers, and number of charges of the composites at room temperature were found to be dependent on CB content. The applicability of the composites to antistatic charge dissipation was examined. Dependence of the microwave properties of the epoxy/CB composites on the volume fraction of CB particles and frequency were studied. Moreover the permittivity as a function of frequency of the composites was studied. The electromagnetic wave shielding of epoxy/CB composites is dominant by both reflection and absorption. Composites can find applications in antistatic charge dissipation and in suppression of electromagnetic interference and stealth technology. POLYM. COMPOS., 2008. © 2007 Society of Plastics Engineers

No abstract

No abstract

No abstract