No abstract

A new copper(II) fluorescent sensor 5,10,15,20-tetra((p-N,N-bis(2-pyridyl)amino)phenyl)porphyrin zinc (1) has been designed and synthesized by the Ullmann-type condensation of bromoporphyrin zinc with 2,2'-dipyridylamine (dpa) under copper powder as a catalyst as well as with K2CO3 as the base in a DMF solution. It consists of two separately functional moieties: the zinc porphyrin performs as a fluorophore, and the dpa-linked-to-zinc porphyrin acts as a selected binding site for metal ions. It displays a high selectivity and antidisturbance for the Cu2+ ion among the metal ions examined (Na+, Mg2+, Cr3+, Mn2+, Fe2+, Co2+, Ni2+, Cu2+, Ag+, Zn2+, Cd2+, Hg2+, and Fe3+) and exhibits fluorescence quenching upon the binding of the Cu2+ ion with an "on-off"-type fluoroionophoric switching property. The detection limit is found to be 3.3 x 10(-7) M (3s blank) for Cu2+ ion in methanol solution, and its fluorescence can be revived by the addition of EDTA disodium solution. The design strategy and remarkable photophysical properties of sensor 1 help to extend the development of fluorescent sensors for metal ions.

The destabilization of crude oil emulsions by polyoxyethylene nonylphenols as inhibitors has been investigated at a water-to-oil volume ratio of 1:1, as a function of the HLB (hydrophilic-lipophilic balance) and concentration. The results show that the stability of crude oil emulsion begins to level off after a critical surfactant concentration, which seems to correspond to their critical micelle concentration (CMC). A stability minimum was found after the stability plateau region, which corresponds to the inversion of emulsion from W/O to O/W. Furthermore, the inhibitor with HLB = 14.2 has the highest efficiency for demulsification with the highest separation rate and the lowest inversion point, whereas inhibitors with higher HLB are less effective, which may be due to the network formation by their very long oxyethyl headgroups and interactions with indigenous components of the crude oil.

The micellization process of sodium bis(4-phenylbutyl) sulfosuccinate (SBPBS) has been studied compared to that of sodium bis(2-ethylhexyl) sulfosuccinate (AOT) by surface tension, steady-state fluorescence, microcalorimetry, dynamic light scattering (DLS), and transmission electron microscopy (TEM) measurements. Meanwhile, the interaction of these two surfactants with hydrophobically modified poly(acrylamide) (HMPAM) was investigated. The results show that the surface tension at the critical micelle concentration (cmc) of SBPBS and the micropolarity probed by pyrene in SBPBS aggregates are both larger than those of AOT. The enthalpy change of micellization (DeltaH(mic)) of AOT is endothermic, while it is exothermic for SBPBS. Strong pi-pi interaction among the adjacent phenyl groups of SBPBS molecules is likely the cause for the above properties of SBPBS. Moreover, vesicles are observed for AOT and SBPBS by DLS and TEM, especially for AOT, whose micelle-vesicle transition has been first confirmed by its calorimetric curve. In the surfactant-HMPAM systems, the critical aggregation concentration (cac), the saturation concentration of aggregation (C(2)), and the thermodynamic parameters of binding have also been determined. The conclusion may be drawn that the binding strength of SBPBS onto HMPAM is stronger than that of AOT.

No abstract