No abstract

Gel polymer electrolytes (GPEs) with polyacrylonitrile (PAN)-based polymer, ethylene carbonate (EC) and propylene carbonate (PC) plasticizers, and different amounts of tetrabutylammonium iodide (TBAI) salt and iodine (I2) have been prepared and used in dyesensitized solar cells (DSSCs). The maximum room temperature conductivity of 5.14 mS cm−1 is obtained for electrolyte with a composition of 8 wt% PAN-30 wt% EC-30 wt% PC-30 wt% TBAI-2 wt% I2 (S3 electrolyte) which influenced by the highest charge carrier density of 7.93 × 1020 cm−3 estimated from fitting the impedance Nyquist plot. The DSSC fabricated with S3 electrolyte revealed the highest power conversion efficiency of 3.45% with open-circuit voltage (Voc) of 582 mV and short-circuit current density (Jsc) of 12.9 mA cm−2. The incident photon-to-current conversion efficiency of the DSSC with highest efficiency is 54.01%. The electrical impedance spectroscopy of the same cell shows the lowest series resistance indicating the superiority of electrolyte charge transport characteristics in DSSC. In addition, electron transfer time constant and electron recombination time , charge collection efficiency , electron diffusion coefficient and diffusion length of DSSC fabricated with GPEs prepared have been estimated by intensity-modulated photocurrent spectroscopy and intensity-modulated photovoltage spectroscopy techniques. The DSSC with highest efficiency shows lowest of 34.46 ms and highest of 90.41 ms due to the huge amount of TBA+ ions that covered the surface area of mesoporous TiO2. The of 0.62, D of 4.00 × 10−5 cm2 s−1 and of 19.02 μm further support the photovoltaic efficiency of DSSC.

No abstract

The objective of this work is to investigate the performance of chlorophyll sensitized solar cells (CSSCs) with gel electrolyte based on polyvinyl alcohol (PVA) with single iodide salt (potassium iodide (KI)) and double salt (KI and tetrapropylammonium iodide (TPAI)). Chlorophyll was extracted from the bryophyteHyophila involuta. The CSSC with electrolyte containing only KI salt produced a short circuit current density (Jsc) of 4.59 mA cm−2, open circuit voltage (Voc) of 0.61 V, fill factor (FF) of 0.64, and efficiency (η) of 1.77%. However, the CSSC with double salt electrolyte exhibitedJscof 5.96 mA cm−2,Vocof 0.58 V, fill factor FF of 0.58, andηof 2.00%. Since CSSC with double salt electrolyte showed better efficiency, other cells fabricated will use the double salt electrolyte. On addition of 0.7 M tetrabutyl pyridine (TBP) to the double salt electrolyte, the cell’s efficiency increased to 2.17%,Jsc=5.37 mA cm−2,Voc=0.55 V, and FF = 0.73. With 5 mM chenodeoxycholic acid (CDCA) added to the chlorophyll, the light to electricity efficiency increased to 2.62% withJscof 8.44 mA cm−2,Vocof 0.54 V, and FF of 0.58.

No abstract

No abstract

No abstract

No abstract