We report on the realization, calibration, and test outdoor of a 19-inches rack 3-units sized Quartz Enhanced Photoacoustic Spectroscopy (QEPAS) trace gas sensor designed for real-time carbon monoxide monitoring in ambient air. Since CO acts as a slow energy relaxer when excited in the mid-infrared spectral region, its QEPAS signal is affected by the presence of relaxation promoters, such as water vapor, or quenchers like molecular oxygen. We analyzed in detail all the CO relaxation processes with typical collisional partners in an ambient air matrix and used this information to evaluate oxygen and humidity-related effects, allowing the real CO concentration to be retrieved. The sensor was tested outdoor in a trafficked urban area for several hours providing results comparable with the daily averages reported by the local air inspection agency, with spikes in CO concentration correlated to the passages of heavy-duty vehicles.

No abstract

We report on a fiber-coupled, quartz-enhanced photoacoustic spectroscopy (QEPAS) near-IR sensor for sequential detection of methane (CH4 or C1) and ethane (C2H6 or C2) in air. With the aim of developing a lightweight, compact, low-power-consumption sensor suitable for unmanned aerial vehicles (UAVs)-empowered environmental monitoring, an all-fiber configuration was designed and realized. Two laser diodes emitting at 1653.7 nm and 1684 nm for CH4 and C2H6 detection, respectively, were fiber-combined and fiber-coupled to the collimator port of the acoustic detection module. No cross talk between methane and ethane QEPAS signal was observed, and the related peak signals were well resolved. The QEPAS sensor was calibrated using gas samples generated from certified concentrations of 1% CH4 in N2 and 1% C2H6 in N2. At a lock-in integration time of 100 ms, minimum detection limits of 0.76 ppm and 34 ppm for methane and ethane were achieved, respectively. The relaxation rate of CH4 in standard air has been investigated considering the effects of H2O, N2 and O2 molecules. No influence on the CH4 QEPAS signal is expected when the water vapor concentration level present in air varies in the range 0.6–3%.

In this paper the performances of two spectrophones for quartz-enhanced photoacoustic spectroscopy (QEPAS)-based ethane gas sensing were tested and compared. Each spectrophone contains a quartz tuning fork (QTF) acoustically coupled with a pair of micro-resonator tubes and having a fundamental mode resonance frequency of 32.7 kHz (standard QTF) and 12.4 kHz (custom QTF), respectively. The spectrophones were implemented into a QEPAS acoustic detection module (ADM) together with a preamplifier having a gain bandwidth optimized for the respective QTF resonance frequency. Each ADM was tested for ethane QEPAS sensing, employing a custom pigtailed laser diode emitting at ~1684 nm as the exciting light source. By flowing 1% ethane at atmospheric pressure, a signal-to-noise ratio of 453.2 was measured by implementing the 12.4 kHz QTF-based ADM, ~3.3 times greater than the value obtained using a standard QTF. The minimum ethane concentration detectable using a 100 ms lock-in integration time achieving the 12.4 kHz custom QTF was 22 ppm.

The current state of the art of single-photon detectors operating in the mid-infrared wavelength range is reported in this review. These devices are essential for a wide range of applications, such as mid-infrared quantum communications, sensing, and metrology, which require detectors with high detection efficiency, low dark count rates, and low dead times. The technological challenge of moving from the well-performing and commercially available near-infrared single-photon detectors to mid-infrared detection is discussed. Different approaches are explored, spanning from the stoichiometric or geometric engineering of a large variety of materials for infrared applications to the exploitation of alternative novel materials and the implementation of proper detection schemes. The three most promising solutions are described in detail: superconductive nanowires, avalanche photodiodes, and photovoltaic detectors.

No abstract

The generation of single photons in the mid-infrared spectral region is attracting the interest of scientific and technological research, motivated by the potential improvements that many important and emerging applications, such as quantum sensing, metrology and communication, could benefit from. This review reports the progress in short and mid-infrared single photon generation, focusing on probabilistic sources based on the two non-linear processes of spontaneous parametric downconversion (SPDC) and four wave mixing (FWM). On one hand, numerical simulations of mid-infrared SPDC are described as a powerful tool to assist and guide the experimental realization, along with the implementation and engineering of novel non-linear materials. On the other hand, the advantages offered by FWM in silicon waveguides in terms of integration, miniaturization and manufacturability are presented, providing an optimal technology for integrated quantum applications.

The use of statistical estimation theory to boost the metrological performance of the measurement apparatus is becoming increasingly popular in a wide range of applications. Recently, such an approach has been adopted in Hong Ou Mandel interferometry, setting a new record in time delay and polarization measurement. Here, we extend these pioneering experiments in the telecom range to unlock the full potential of the information-based approach combined with a versatile spectral range, aiming for its adoption in fiber-coupled devices of up to hundreds of kilometers long as bobines or optical networks. Our measurement saturates the Cramér-Rao bound and in a long lasting experiment returns an Allan deviation of the polarization angle of 0.002 degs in 1 h of integration time.