Molecular spin crossover complexes are promising candidates for mechanical actuation purposes. The relationships between their crystal structure and mechanical properties remain, however, not well understood. In this study, combining high pressure synchrotron X-ray diffraction, nuclear inelastic scattering, and micromechanical measurements, we assessed the effective macroscopic bulk modulus ( B = 11.5 ± 1.5 GPa), Young's modulus ( Y = 10.9 ± 1.0 GPa), and Poisson's ratio (ν = 0.34 ± 0.04) of the spin crossover complex [Fe(HB(tz))] (tz = 1,2,4-triazol-1-yl). Crystal structure analysis revealed a pronounced anisotropy of the lattice compressibility, which was correlated with the difference in spacing between the molecules as well as by the distribution of the stiffest C-H···N interactions in different crystallographic directions. Switching the molecules from the low spin to the high spin state leads to a remarkable drop of the Young's modulus to 7.1 ± 0.5 GPa both in bulk and thin film samples. The results highlight the application potential of these films in terms of strain (ε = -0.17 ± 0.05%), recoverable stress (σ = -21 ± 1 MPa), and work density ( W/V = 15 ± 6 mJ/cm).

We report on a bistable MEMS device actuated by spin-crossover molecules. The device consists of a freestanding silicon microcantilever with an integrated piezoresistive detection system, which was coated with a 140 nm thick film of the [Fe(HB(tz) ) ] (tz=1,2,4-triazol-1-yl) molecular spin-crossover complex. Switching from the low-spin to the high-spin state of the ferrous ions at 338 K led to a reversible upward bending of the cantilever in agreement with the change in the lattice parameters of the complex. The strong mechanical coupling was also evidenced by the decrease of approximately 66 Hz in the resonance frequency in the high-spin state as well as by the drop in the quality factor around the spin transition.

Silicon MEMS cantilevers coated with a 200 nm thin layer of the molecular spin crossover complex [Fe(H2B(pz)2)2(phen)] (H2B(pz)2 = dihydrobis(pyrazolyl)borate and phen = 1,10-phenantroline) were actuated using an external magnetic field and their resonance frequency was tracked by means of integrated piezoresistive detection. The light-induced spin-state switching of the molecules from the ground low spin to the metastable high spin state at 10 K led to a well-reproducible shift of the cantilever's resonance frequency (Δfr = −0.52 Hz). Control experiments at different temperatures using coated as well as uncoated devices along with simple calculations support the assignment of this effect to the spin transition. This latter translates into changes in mechanical behavior of the cantilever due to the strong spin-state/lattice coupling. A guideline for the optimization of device parameters is proposed so as to efficiently harness molecular scale movements for large-scale mechanical work, thus paving the road for nanoelectromechanical systems (NEMS) actuators based on molecular materials.

No abstract

Silicon microcantilevers can be used to measure the rheological properties of complex fluids. In this paper, two different methods will be presented. In the first method, the microcantilever is used to measure the hydrodynamic force exerted by a confined fluid on a sphere that is attached to the microcantilever. In the second method, the measurement of the microcantilever's dynamic spectrum is used to extract the hydrodynamic force exerted by the surrounding fluid on the microcantilever. The originality of the proposed methods lies in the fact that not only may the viscosity of the fluid be measured, but also the fluid's viscoelasticity, that is, both viscous and elastic properties, which are key parameters in the case of complex fluids. In both methods, the use of analytical equations permits the fluid's complex shear modulus to be extracted and expressed as a function of shear stress and/or frequency.

No abstract

Fe II (Htrz) 2 (trz)](BF 4 ) spin crossover particles of 85 nm mean size are dispersed in an SU-8 polymer matrix and spray-coated onto silicon microcantilevers. The subsequent photothermal treatment of the polymer resist leads to micrometer thick, smooth, and homogeneous coatings, which exhibit well-reproducible actuation upon the thermally induced spin transition. The actuation amplitude as a function of temperature is accurately determined by combining integrated piezoresistive detection with external optical interferometry, which allows for the assessment of the associated actuation force (9.4 mN), stress (28 MPa), strain (1.0%), and work density (140 mJ cm −3 ) through a stratified beam model. The dynamical mechanical characterization of the films evidences an increase of the resonance frequency and a concomitant decrease of the damping in the high-temperature phase, which arises due to a combined effect of the thickness and mechanical property changes. The spray-coating approach is also successfully extended to scale up the actuators for the centimeter range on a polymer substrate providing perspectives for biomimetic soft actuators.

Incorporating functional molecules into sensor devices is an emerging area in molecular electronics that aims at exploiting the sensitivity of different molecules to their environment and turning it into an electrical signal. Among the emergent and integrated sensors, microelectromechanical systems (MEMS) are promising for their extreme sensitivity to mechanical events. However, to bring new functions to these devices, the functionalization of their surface with molecules is required. Herein, we present original electronic devices made of an organic microelectromechanical resonator functionalized with switchable magnetic molecules. The change of their mechanical properties and geometry induced by the switching of their magnetic state at a molecular level alters the device’s dynamical behavior, resulting in a change of the resonance frequency. We demonstrate that these devices can be operated to sense light or thermal excitation. Moreover, thanks to the collective interaction of the switchable molecules, the device behaves as a non-volatile memory. Our results open up broad prospects of new flexible photo- and thermo-active hybrid devices for molecule-based data storage and sensors.