Water invasion, associated with hydraulic fracturing, often causes hydrocarbon-mobility hindrance, known as water blocking. The effect on productivity is largely dependent on saturation profiles inside fractures and formation matrix. Enhancement to hydrocarbon recovery has been reported in some field cases after shutting in wells for long time periods. Here we conduct numerical-simulation studies to investigate the effect of well shut-in on initial productivity and long-term recovery.
We replicate post-fracturing conditions with an extensive fracture network that intermeshes with formation matrix. The models are designed using either logarithmically spaced, locally refined grid or embedded discrete fracture model (EDFM). Starting with varying initial fluid distributions, we compare productivity and recovery of two cases: one that does not start production until after 32 days of shut-in, and another that starts immediately without soaking. For the initial conditions that favor shut-in, we carry out case studies in attempt to find the ideal shut-in conditions for maximum recovery improvement.
Results confirm improvement in early productivity after shut-in for all the considered initial fluid-distribution cases. The majority of cases exhibit net gain in total oil recovery. We report improvement in recovery of as much as 5%, owing to spontaneous imbibition. Imbibition of the injected water into formation matrix causes fluid redistribution and favored mobility for the non-wetting phase, and hence enhanced hydrocarbon productivity. The simulations take into account spontaneous imbibition and gravity segregation, but do not consider geo-mechanical forces, water adsorption or chemical reactions. When capillary forces are neglected, well productivity and recovery decrease, even when the well is not shut in. Such observations underline imbibition counter-current flow as an important production mechanism that should not be neglected in shale-oil-reservoir simulations.
Polymer flooding can be a viable alternative to enhance oil recovery of heavy oil fields. The comparison of water and polymer flooding requires a reliable reservoir numerical model to safely ensure the decision analysis including uncertainties and involving a significant amount of simulation runs. Reservoir engineers usually work-around this problem using fast models to reduce computational time; however, it is important to maintain the reliability of heterogeneous reservoir models. Therefore, the proposed work demonstrates how the grid size impacts on accuracy of results and both the time and computational resources. In addition, it is performed an analysis to establish how the typical physical phenomena related to the polymer flooding impact the applicability of the proposed methodology.
A highly heterogeneous heavy oil field is used in our proposed studies. The application is conducted to assist pilot test wells. Initially, the definition of the reference strategy (OTM) is presented. In this case study, the OTM strategy is based on the optimization of location and number of wells. Secondly, the effect of grid size on the process is evaluated through two procedures: (1) DA method: a selection of grid size defined by drainage area of the selected wells; and (2) UP method: upscaling is performed in the simulation model. Then, production parameters resulting from models of both procedures (DA and UP) are compared with OTM results. The definition of which procedure is better to represent the wells of interest is performed. Finally, the impact of three polymer flooding physical phenomena (degradation, adsorption and Non-Newtonian effect) on production results is presented, in order to verify the accuracy of the generated fast models in maintained considering these effects.
The DA method present good accuracy for reservoir response compared to the reference OTM results. Differently, UP models are not as accurate as DA models for production results indicators. In conclusion, the application of the methodology allows choosing the DA over the UP technique to support our decision in the investigated recovery methods, showing a reliable and fast procedure. Finally, this procedure shows excellent applicability and robustness when a typical polymer flooding study is carried out: the evaluation of physical phenomena impact on production results based on wells of interest.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.