The torque transfer capability as well as long-term endurance are essential for wet multi-plate clutches. The quality of the torque transmission process largely depends on the tribological system consisting of friction pairing, lubricant and applied loads. The requirements on friction linings in wet multi-plate clutches increase continuously due to stricter CO2 reduction regulations and the demand of higher power densities.There is a lack of published data and information about the friction behavior of modern Carbon friction linings in wet multi-plate clutch applications, although these friction materials have successfully proven their performance capabilities over the last two decades in synchronizers. Therefore, this article presents results from experimental studies on the friction behavior of innovative Carbon friction linings carried out on a component test rig. Friction screening tests were performed with Carbon-fiber reinforced plastic (CFRP) and Carbon-fiber reinforced Carbon (C/C) linings in brake and constant slip operation. Furthermore, our research included long-term tests with different lubricants (engine/marine/tractor oil).Results show that modern Carbon friction linings can offer advantages over other materials. In the friction screening (brake and constant slip operations) and long-term tests, the torque transfer capability of both friction linings is very stable, even at high specific loads—sliding velocities near 30 m/s and axial pressures of 2.5 MPa. Influences of sliding velocity, pressure and lubricant on the friction performance are presented. Furthermore, the gradient of the Coefficient of Friction (CoF) curve usually decreases at the end of the engagement to enable good control and shift comfort.
Safety and comfort, while ensuring torque transfer capability, are essential for wet multi-plate clutches. The safety of the torque transmission process largely depends on the endurance of the tribological system against spontaneous and long-term damages. Modern Carbon friction linings in wet multi-plate clutch applications offer superior wear resistance compared to other friction materials, but there is hardly any published data on their spontaneous damage behavior. This article therefore presents results from experimental studies on the spontaneous damage of innovative Carbon friction linings carried out on a component test rig. Furthermore, the influence of different steel plate thicknesses (3.5 mm vs. 6 mm) was investigated. 16 step tests, including visual assessments of the clutches, were performed with Carbon-fiber reinforced plastic (CFRP) and Carbon-fiber reinforced Carbon (C/C) linings in brake operations.The results of the step tests are documented in friction work over friction power diagrams. Results show excellent endurance of modern Carbon friction linings against spontaneous damage and thus makes them suitable for safety relevant high-performance applications. There was no clear influence of the steel plate thickness on spontaneous damage. However, the C/C friction lining ran at a specific energy of up to 5.26 J/mm2 in combination with sliding velocities of up to 67 m/s (high speed application) without failure. This is the highest published spontaneous damage resistance identified for wet clutches.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.