No abstract

Tungsten is the major candidate material for the armour of plasma facing components in future fusion devices. To overcome the intrinsic brittleness of tungsten, which strongly limits its operational window, a W-fibre enhanced W-composite material (W f /W) has been developed incorporating extrinsic toughening mechanisms. Small W f /W samples show a large increase in toughness. Recently, a large sample ( 50 × 50 × 3 mm 3 ) with more than 2000 long fibres has been successfully produced allowing further mechanical and thermal testing. It could be shown that even in a fully embrittled state, toughening mechanisms as crack bridging by intact fibres, as well as the energy dissipation by fibre-matrix interface debonding and crack deflection are still effective. A potential problem with the use of pure W in a fusion reactor is the formation of radioactive and highly volatile WO 3 compounds and their potential release under accidental conditions. It has been shown that the oxidation of W can be strongly suppressed by alloying with elements forming stable oxides.

Highly efficient energy conversion and storage technologies such as high‐temperature solid oxide fuel and electrolysis cells, all‐solid‐state batteries, gas separation membranes, and thermal barrier coatings for advanced turbine systems depend on advanced materials. In all cases, processing of ceramics and metals starting from powders plays a key role and is often a challenging task. Depending on their composition, such powder materials often require high sintering temperatures and show an inherent risk of abnormal grain growth, evaporation, chemical reaction, or decomposition, especially in the case of long dwelling times. Electric current‐assisted sintering (ECAS) techniques are promising to overcome these restrictions, but a lot of fundamental and practical challenges must be solved properly to take full advantage of these techniques. A broad and long‐term expertise in the field of ECAS techniques and comprehensive facilities including conventional field‐assisted sintering technology/spark plasma sintering (FAST/SPS), hybrid FAST/SPS (with additional heater), sinter forging, and flash sintering (FS) devices are available at the Institute of Energy and Climate Research: Materials Synthesis and Processing (IEK‐1). Herein, main advantages and challenges of these techniques are discussed and the concept to overcome current limitations is introduced on selected examples.

No abstract

No abstract

No abstract

No abstract

No abstract