Protein aggregation is important in food processing, and this work investigated the aggregation of food proteins as a source of amyloid fibrils for use in bionanotechnology. Both purified and crude mixtures of albumin proteins were denatured by heat, which caused aggregation to occur. Protein denaturation was measured by using circular dichroism spectrometry and by following thioflavin T fluorescence, which is widely used as a diagnostic test for amyloid formation. There was a good correlation between the increase in thioflavin T fluorescence and loss of helical structure as the temperature was increased. Formation of thioflavin T fluorescence was dependent on temperature, but less dependent on salt and protein concentration. X-ray fiber diffraction patterns of denatured bovine serum albumin suggested that the protein had a similar cross-beta structure to that of amyloid fibrils. These results are consistent with the aggregates seen during food processing, being amyloid-like in nature.

No abstract

During catalysis, all Rubisco (D-ribulose-1,5-bisphosphate carboxylase/oxygenase) enzymes produce traces of several by-products. Some of these by-products are released slowly from the active site of Rubisco from higher plants, thus progressively inhibiting turnover. Prompted by observations that Form I Rubisco enzymes from cyanobacteria and red algae, and the Form II Rubisco enzyme from bacteria, do not show inhibition over time, the production and binding of catalytic by-products was measured to ascertain the underlying differences. In the present study we show that the Form IB Rubisco from the cyanobacterium Synechococcus PCC6301, the Form ID enzyme from the red alga Galdieria sulfuraria and the low-specificity Form II type from the bacterium Rhodospirillum rubrum all catalyse formation of by-products to varying degrees; however, the by-products are not inhibitory under substrate-saturated conditions. Study of the binding and release of phosphorylated analogues of the substrate or reaction intermediates revealed diverse strategies for avoiding inhibition. Rubisco from Synechococcus and R. rubrum have an increased rate of inhibitor release. G. sulfuraria Rubisco releases inhibitors very slowly, but has an increased binding constant and maintains the enzyme in an activated state. These strategies may provide information about enzyme dynamics, and the degree of enzyme flexibility. Our observations also illustrate the phylogenetic diversity of mechanisms for regulating Rubisco and raise questions about whether an activase-like mechanism should be expected outside the green-algal/higher-plant lineage.

Significance CRISPR-Cas systems provide prokaryotic adaptive immunity against invading genetic elements. For immunity, fragments of invader DNA are integrated into CRISPR arrays by Cas1 and Cas2 proteins. Type I-F systems contain a unique fusion of Cas2 to Cas3, the enzyme responsible for destruction of invading DNA. Structural, biophysical, and biochemical analyses of Cas1 and Cas2-3 from Pectobacterium atrosepticum demonstrated that they form a 400-kDa complex with a Cas1 4 :Cas2-3 2 stoichiometry. Cas1–Cas2-3 binds, processes, and catalyzes the integration of DNA into CRISPR arrays independent of Cas3 activity. The arrangement of Cas3 in the complex, together with its redundant role in processing and integration, supports a scenario where Cas3 couples invader destruction with immunization—a process recently demonstrated in vivo.

The first directed mutant of a higher plant ribulosebisphosphate carboxylase/oxygenase (Rubisco), constructed by chloroplast transformation, is catalytically impaired but still able to support the plant's photosynthesis and growth (Whitney, S. M., von Caemmerer, S., Hudson, G. S., and Andrews, T. J. (1999) Plant Physiol. 121, 579 -588). This mutant enzyme has a Leu to Val substitution at residue 335 in the flexible loop 6 of the large subunit, which closes over the substrate during catalysis. Its active site was intact, as judged by its barely impaired competency in the initial enolization step of the reaction sequence, and its ability to bind tightly the intermediate analog, 2-carboxy-D-arabinitol-1,5-bisphosphate. Prompted by observations that the mutant enzyme displayed much less slow inhibition during catalysis in vitro than the wild type, its tendency to catalyze side reactions and its response to the slow inhibitor D-xylulose-1,5-bisphosphate were studied. The lessening in slow inhibition was not caused by reduced production of inhibitory side products. Except for pyruvate production, these reactions were strongly enhanced by the mutation, as was the ability to catalyze the carboxylation of D-xylulose-1,5-bisphosphate. Rather, reduced inhibition was the result of lessened sensitivity to these inhibitors. The slow isomerization phase that characterizes inhibition of the wild-type enzyme by D-xylulose-1,5-bisphosphate was completely eliminated by the mutation, and the mutant was more adept than the wild type in catalyzing the benzylic acid-type rearrangement of D-glycero-2,3-pentodiulose-1,5-bisphosphate (produced by oxidation of the substrate, D-ribulose-1,5-bisphosphate). These observations are consistent with increased flexibility of loop 6 induced by the mutation, and they reveal the underlying mechanisms by which the side reactions cause slow inhibition.Ribulose-1,5-bisphosphate carboxylase/oxygenase (Rubisco, 1 EC 4.1.1.39) catalyzes the carboxylation and oxygenation of ribulose-P 2 in photosynthetic CO 2 fixation and photorespiration (1-5). Despite excellent crystal structures of various liganded and unliganded Rubiscos from various sources (6) and intensive mutagenic study of algal (3) and bacterial (7) Rubiscos, progress toward understanding the catalytic mechanism has been hampered by an inability to express the dominant higher plant form of the enzyme in heterologous hosts. This precluded application of the power of directed mutagenesis to the higher plant enzyme until Whitney et al. (8) constructed the first such mutant by chloroplast transformation in the natural host, tobacco. Because it was desirable to maintain photosynthetic viability, a mutation (a Leu to Val substitution at residue 335 of the plastid-encoded large subunit) was chosen with the aim of changing the kinetic parameters (particularly the CO 2 /O 2 specificity (9)) as much as possible without seriously disabling catalytic performance at elevated CO 2 concentration. The substitution successfully reduced the CO 2 /O 2 specificity ...

The potential for protein tectons to be used in nanotechnology is increasingly recognized, but the repertoire of stable proteins that assemble into defined shapes in response to an environmental trigger is limited. Peroxiredoxins (Prxs) are a protein family that shows an amazing array of supramolecular assemblies, making them attractive tectons. Human Prx3 (hPrx3) forms toroidal oligomers characteristic of the Prx family, but no structure has been solved to date. Here we report the first 3-D structure of this protein, derived from single-particle analysis of TEM images, establishing a dodecameric structure. This result was supported by SAXS measurements. We also present the first detailed structure of a double toroidal Prx from a higher organism determined by SPA. Guided by these structures, variants of the protein were designed to facilitate controlled assembly of protein nanostructures through the association of the toroids. We observed an enhanced population of stacked toroids, as seen by TEM; nanocages and interlocked toroids were also visible. Low pH was successfully predicted to generate long ordered nanotubes. Control over the length of the tubes was gained by adding ammonium sulfate to the assembly buffer. These versatile assembly properties demonstrate the considerable potential of hPrx3 as a tecton for protein nanotechnology.

In plants, the lysine biosynthetic pathway is an attractive target for both the development of herbicides and increasing the nutritional value of crops given that lysine is a limiting amino acid in cereals. Dihydrodipicolinate synthase (DHDPS) and dihydrodipicolinate reductase (DHDPR) catalyse the first two committed steps of lysine biosynthesis. Here, we carry out for the first time a comprehensive characterisation of the structure and activity of both DHDPS and DHDPR from Arabidopsis thaliana. The A. thaliana DHDPS enzyme (At-DHDPS2) has similar activity to the bacterial form of the enzyme, but is more strongly allosterically inhibited by (S)-lysine. Structural studies of At-DHDPS2 show (S)-lysine bound at a cleft between two monomers, highlighting the allosteric site; however, unlike previous studies, binding is not accompanied by conformational changes, suggesting that binding may cause changes in protein dynamics rather than large conformation changes. DHDPR from A. thaliana (At-DHDPR2) has similar specificity for both NADH and NADPH during catalysis, and has tighter binding of substrate than has previously been reported. While all known bacterial DHDPR enzymes have a tetrameric structure, analytical ultracentrifugation, and scattering data unequivocally show that At-DHDPR2 exists as a dimer in solution. The exact arrangement of the dimeric protein is as yet unknown, but ab initio modelling of x-ray scattering data is consistent with an elongated structure in solution, which does not correspond to any of the possible dimeric pairings observed in the X-ray crystal structure of DHDPR from other organisms. This increased knowledge of the structure and function of plant lysine biosynthetic enzymes will aid future work aimed at improving primary production.

In plants and bacteria, the branch point of (S)-lysine biosynthesis is the condensation of (S)-aspartate-beta-semialdehyde [(S)-ASA] and pyruvate, a reaction catalyzed by dihydrodipicolinate synthase (DHDPS, EC 4.2.1.52). It has been proposed that Arg138, a residue situated at the entrance to the active site of DHDPS, is responsible for binding the carboxyl of (S)-ASA and may additionally be involved in the mechanism of (S)-lysine inhibition. This study tests these assertions by mutation of Arg138 to both histidine and alanine. Following purification, DHDPS-R138H and DHDPS-R138A each showed severely compromised activity (approximately 0.1% that of the wild type), and the apparent Michaelis-Menten constant for (S)-ASA in each mutant, calculated using a pseudo-single substrate analysis, was significantly higher than that of the wild type. This provides good evidence that Arg138 is indeed essential for catalysis and plays a key role in substrate binding. To test whether structural changes could account for the change in kinetic behavior, the solution structure was probed via far-UV circular dichroism, confirming that the mutations at position 138 did not modify secondary structure. The crystal structures of both mutant enzymes were determined, confirming the presence of the mutations and suggesting that Arg138 plays an important role in catalysis: the stabilization of the catalytic triad residues, a motif we have previously demonstrated to be essential for activity. In addition, the role of Arg138 in (S)-lysine inhibition was examined. Both mutant enzymes showed the same IC(50) values as the wild type but different partial inhibition patterns, from which it is concluded that arginine 138 is not essential for (S)-lysine inhibition.