No abstract

In this work, we compared two methods (incipient wetness and melting) for the encapsulation of ibuprofen in the pores of Mobil Crystalline Material 41 (MCM-41) through NMR (nuclear magnetic resonance) spectroscopy. (1)H NMR spectra were recorded under very fast MAS (sample spinning 60 kHz) conditions in both 1D and 2D mode (NOESY sequence). We also performed (13)C cross-polarization magic angle spinning (CP/MAS) experiments, (13)C single pulse experiments (SPE), and (1)H-(13)C HSQC HR/MAS (heteronuclear single quantum coherence high resolution) HR/MAS correlations. Evaluation of the encapsulation methods included an analysis of the filling factor of the drug into the pores. The stability of Ibu/MCM in an environment of ethanol or water vapor was tested. Our study showed that melting a mixture of Ibu and MCM is a much more efficient method of confining the drug in the pores compared to incipient wetness. The optimal experiments for the former method achieved a filling factor of approximately 60%. We concluded that the major limitation to the applicability of the incipient wetness method (filling factor ca. 20%) is the high affinity of solvent (typically ethanol) for MCM-41. We found that even ethanol vapor can remove Ibu from the pores. When a sample of Ibu/MCM was stored for a few hours in a closed vessel with ethanol vapor, Ibu was transported from the pores to the outer walls of MCM. We observed a similar phenomenon with water vapor, although this process is slower compared to the analogous procedure using ethanol. Our study clearly demonstrates that existing methods used to encapsulate drugs in mesoporous silica nanoparticles (MSNs) require reevaluation.

Grinding and melting methods were employed for synthesis of pharmaceutical cocrystals formed by racemic (R/S) and entiomeric (S) ibuprofen (IBU) and nicotinamide (NA) as coformer. Obtained (R/S)-IBU:NA and (S)-IBU:NA cocrystals were fully characterized by means of advanced one- and two-dimensional solid state nuclear magnetic resonance (SS NMR) techniques with very fast magic angle spinning (MAS) at 60 kHz. The distinction in molecular packing and specific hydrogen bonding pattern was clearly recognized by analysis of H,C, and N spectra. It is concluded from these studies that both methods (grinding and melting) provide exactly the same, specific forms of cocrystals. Thermal solvent-free (TSF) approach was used for loading of (R/S)-IBU:NA and (S)-IBU:NA into the pores of MCM-41 mesoporous silica particle (MSP). The progress and efficiency of this process was analyzed by NMR spectroscopy. It has been confirmed that TSF method is an effective and safe technique of filling the MSP pores with active pharmaceutical ingredients (APIs). By analyzing the NMR results, it has been further proved that excess of IBU and NA components, which are not embedded into the pores during melting and cooling, crystallize on the MCM-41 walls preserving very specific arrangement, characteristic for crystalline samples. By investigating kinetic of release for (R/S)-IBU/MCM-41, (S)-IBU:NA/MCM-41, and (R/S)-IBU:NA/MCM-41 samples containing active components exclusively inside of the pores, it was revealed that release of IBU is much faster for the first of the samples compared to those containing IBU and NA inside the pores. The hypothesis that the rate of release of API can be controlled by specific composition of cocrystal embedded into the MSP pore was further supported by study of (R/S)-IBU:BA/MCM-41 sample with benzoic acid (BA) as coformer.