BackgroundAlkaline phosphatase (AP) catalyzes the hydrolytic cleavage of phosphate monoesters under alkaline conditions and plays important roles in microbial ecology and molecular biology applications. Here, we report on the first isolation and biochemical characterization of a thermolabile AP from a metagenome.ResultsThe gene encoding a novel AP was isolated from a metagenomic library constructed with ocean-tidal flat sediments from the west coast of Korea. The metagenome-derived AP (mAP) gene composed of 1,824 nucleotides encodes a polypeptide with a calculated molecular mass of 64 kDa. The deduced amino acid sequence of mAP showed a high degree of similarity to other members of the AP family. Phylogenetic analysis revealed that the mAP is shown to be a member of a recently identified family of PhoX that is distinct from the well-studied classical PhoA family. When the open reading frame encoding mAP was cloned and expressed in recombinant Escherichia coli, the mature mAP was secreted to the periplasm and lacks an 81-amino-acid N-terminal Tat signal peptide. Mature mAP was purified to homogeneity as a monomeric enzyme with a molecular mass of 56 kDa. The purified mAP displayed typical features of a psychrophilic enzyme: high catalytic activity at low temperature and a remarkable thermal instability. The optimal temperature for the enzymatic activity of mAP was 37°C and complete thermal inactivation of the enzyme was observed at 65°C within 15 min. mAP was activated by Ca2+ and exhibited maximal activity at pH 9.0. Except for phytic acid and glucose 1-phosphate, mAP showed phosphatase activity against various phosphorylated substrates indicating that it had low substrate specificity. In addition, the mAP was able to remove terminal phosphates from cohesive and blunt ends of linearized plasmid DNA, exhibiting comparable efficiency to commercially available APs that have been used in molecular biology.ConclusionsThe presented mAP enzyme is the first thermolabile AP found in cold-adapted marine metagenomes and may be useful for efficient dephosphorylation of linearized DNA.

Large-scale screening of enzyme libraries is essential for the development of cost-effective biological processes, which will be indispensable for the production of sustainable biobased chemicals. Here, we introduce a genetic circuit termed the Genetic Enzyme Screening System that is highly useful for high-throughput enzyme screening from diverse microbial metagenomes. The circuit consists of two AND logics. The first AND logic, the two inputs of which are the target enzyme and its substrate, is responsible for the accumulation of a phenol compound in cell. Then, the phenol compound and its inducible transcription factor, whose activation turns on the expression of a reporter gene, interact in the other logic gate. We confirmed that an individual cell harboring this genetic circuit can present approximately a 100-fold higher cellular fluorescence than the negative control and can be easily quantified by flow cytometry depending on the amounts of phenolic derivatives. The high sensitivity of the genetic circuit enables the rapid discovery of novel enzymes from metagenomic libraries, even for genes that show marginal activities in a host system. The crucial feature of this approach is that this single system can be used to screen a variety of enzymes that produce a phenol compound from respective synthetic phenyl-substrates, including cellulase, lipase, alkaline phosphatase, tyrosine phenol-lyase, and methyl parathion hydrolase. Consequently, the highly sensitive and quantitative nature of this genetic circuit along with flow cytometry techniques could provide a widely applicable toolkit for discovering and engineering novel enzymes at a single cell level.

Biocatalytic cyclization is highly desirable for efficient synthesis of biologically derived chemical substances, such as the commodity chemicals ε-caprolactam and δ-valerolactam. To identify biocatalysts in lactam biosynthesis, we develop a caprolactam-detecting genetic enzyme screening system (CL-GESS). The Alcaligenes faecalis regulatory protein NitR is adopted for the highly specific detection of lactam compounds against lactam biosynthetic intermediates. We further systematically optimize the genetic components of the CL-GESS to enhance sensitivity, achieving 10-fold improvement. Using this highly sensitive GESS, we screen marine metagenomes and find an enzyme that cyclizes ω-amino fatty acids to lactam. Moreover, we determine the X-ray crystal structure and catalytic residues based on mutational analysis of the cyclase. The cyclase is also used as a helper enzyme to sense intracellular ω-amino fatty acids. We expect this simple and accurate biosensor to have wide-ranging applications in rapid screening of new lactam-synthesizing enzymes and metabolic engineering for lactam bio-production.

Isoprene is a valuable precursor for synthetic rubber and a signature product of terpenoid pathways. Here, we developed an isoprene biosensor by employing a TbuT transcriptional regulator of Ralstonia pickettii to express a fluorescent reporter gene in response to intracellular isoprene in engineered Escherichia coli. The TbuT regulator recognizes isoprene as its less-preferred effector molecule; thus, we amplified the reporter gene expression using a T7 RNA polymerase-mediated transcriptional cascade and iteratively tuned the promoter transcribing tbuT to improve the sensitivity for detecting isoprene. When the engineered E. coli cells expressed heterologous genes for isoprene biosynthesis, the intracellular isoprene was expelled and the tbuT transcription factor was subsequently activated, leading to gfp expression. The chromosomal isoprene biosensor showed a linear correlation between GFP fluorescence and intracellular isoprene concentration. Using this chromosomal isoprene biosensor, we successfully identified the highest isoprene producer among four different E. coli strains producing different amounts of isoprene. The isoprene biosensor presented here can enable high-throughput screening of isoprene synthases and metabolic pathways for efficient and sustainable production of bioisoprene in engineered microbes.

Bioconversion of C1 chemicals such as methane and methanol into higher carbonchain chemicals has been widely studied. Methanol oxidation catalyzed by methanol dehydrogenase (Mdh) is one of the key steps in methanol utilization in bacterial methylotrophy. In bacteria, few NAD +-dependent Mdhs have been reported that convert methanol to formaldehyde. In this study, an uncharacterized Mdh gene from Lysinibacillus xylanilyticus (Lxmdh) was cloned and expressed in Escherichia coli. The maximum alcohol oxidation activity of the recombinant enzyme was observed at pH 9.5 and 55 • C in the presence of 10 mM Mg 2+. To improve oxidation activity, rational approach-based, site-directed mutagenesis of 16 residues in the putative active site and NAD +-binding region was performed. The mutations S101V, T141S, and A164F improved the enzyme's specific activity toward methanol compared to that of the wild-type enzyme. These mutants show a slightly higher turnover rate than that of wild-type, although their K M values were increased compared to that of wild-type. Consequently, according the kinetic results, S101, T141, and A164 positions may related to the catalytic activity in the active site for methanol dehydrogenation. It should be further studied other mutant variants with high activity for methanol. In conclusion, we characterized a new Lxmdh and its variants that may be potentially useful for the development of synthetic methylotrophy in the future.

We constructed a mesh-grid integrated microwell array which enables easy trapping and consistent addition of droplets. The grid acts as a microchannel structure to guide droplets into the microwells underneath, and also provides open access for additional manipulation in a high-throughput manner. Each droplet in the array forms a stable environment of pico-litre volume to implement a single-cell-based assay.

Genetic circuit-based biosensors are useful in detecting target metabolites or in vivo enzymes using transcription factors (Tx) as a molecular switch to express reporter signals, such as cellular fluorescence and antibiotic resistance. Herein, a phenol-detecting Tx (DmpR) was employed as a critical tool for enzyme engineering, specifically for the rapid analysis of numerous mutants with multiple mutations at the active site of tryptophan-indole lyase (TIL, EC 4.1.99.1). Cellular fluorescence was monitored cell-by-cell using flow cytometry to detect the creation of phenolic compounds by a new tyrosine-phenol-lyase (TPL, EC 4.1.99.2). In the TIL scaffold, target amino acids near the indole ring (Asp137, Phe304, Val394, Ile396 and His463) were mutated randomly to construct a large diversity of specificity variations. Collection of candidate positives by cell sorting using flow cytometry and subsequent shuffling of beneficial mutations identified a critical hit with four mutations (D137P, F304D, V394L, and I396R) in the TIL sequence. The variant displayed one-thirteenth the level of TPL activity, compared with native TPLs, and completely lost the original TIL activity. The findings demonstrate that hypersensitive, Tx-based biosensors could be useful critically to generate new activity from a related template, which would alleviate the current burden to high-throughput screening.

The tyrosine phenol-lyase from Symbiobacterium toebii was engineered to improve both its stability and catalytic activity by the application of random mutagenesis and subsequent reassembly of the acquired mutations. Activity screening of the random library produced four mutants with a two-fold improved activity, whereas parallel screening after heat treatment at 65 degrees C identified three mutants with half-inactivation temperatures improved by up to 5.6 degrees C. The selected mutants were then reassembled using the staggered extension PCR method, and subsequent screening of the library produced seven mutants with up to three-fold improved activity and half-inactivation temperatures improved by up to 11.2 degrees C. Sequence analyses revealed that the stability-improved hits included A13V, E83K and T407A mutations, whereas the activity-improved hits included the additional T129I or T451A mutation. In particular, the A13V mutation was propagated in the hits with improved stability during the reassembly-screening process, indicating the critical nature of the N-terminal moiety for enzyme stability. Furthermore, homology modeling of the enzyme structure revealed that most of the stability mutations were located around the dimer-dimer interface, including the N-terminus, whereas the activity-improving mutations were located further away, thereby minimizing any interference that would be detrimental to the co-improvement of the stability and catalytic activity of the enzyme.