In the present work, anthocyanin (ACN) hybrid nanopigments were synthetized by using a natural pomegranate dye (PD) and calcined hydrotalcite (HT) and montmorillonite (MMT) nanoclays. A wide colour gamut was obtained with MMT-based nanopigments ranging from reddish to bluish hues caused by structural transformations of ACNs at different pH values. However, a buffer effect was observed with HT obtaining samples a similar final colour regardless of the synthesis conditions. Nanopigments added with a biomordant extracted from pomegranate peels showed a different colour compared to the incorporation of a commercial mordant due to the intrinsic colouring properties of the pomegranate bioadditive. The developed nanopigments were incorporated at 7 wt% loading to produce novel polyester-based bionanocomposites which were characterized in terms of thermal, mechanical and colour properties. The encapsulation of PD into the nanoclays improved its thermal stability, in particular for MMT-based nanopigments. The pH changes observed during the nanofillers synthesis affected the final colour of the MMT-based nanocomposites, inducing a general increase in ∆E* and a decrease in gloss values. Slight improvements were obtained in terms of elastic modulus for MMT-based polymer samples confirming the applicability of the developed bionanocomposites as colouring and reinforcement materials. A very similar environmental profile was obtained for MMT and HT-based nanofillers showing MMT-based nanopigments a slightly better general behaviour. The results of the LCA study evidenced the suitability of the processes used in this work to the circular bioeconomy approach through sustainable food waste management and the production of bioplastics using waste substrates.

Vertical farming is considered as a potential solution to increase yield while decreasing resource use and pesticide impacts compared to conventional agriculture. However, the profitability of cultivating ordinary leafy green crops with low market prices in vertical farming is debated. We studied the agronomic feasibility and viability of growing a medicinal plant—Euphorbia peplus—for its ingenol-mebutate content in a modified shipping container farm as an alternative crop cultivation system. The impacts of three hydroponic substrates, three light intensities, three plant localizations and two surface areas on E. peplus yield and cost were tested in several scenarios. The optimization of biomass yield and area surface decreased the cultivation cost, with fresh crop cost per kg ranging from €185 to €59. Three ingenol-mebutate extraction methods were tested. The best extraction yields and cheapest method can both be attributed to ethyl acetate at 120 °C, with a yield of 43.8 mg/kg at a cost of €38 per mg. Modeling of the profitability of a pharmaceutical gel based on ingenol-mebutate showed that economic feasibility was difficult to reach, but some factors could rapidly increase the profitability of this production.

Photoresponsive nanocomposite organically modified silica films were prepared by solution sol-gel processing of organo-silicon alkoxide compounds. Waveguiding at 488 and 514.5 nm proceeded with simultaneous self-inscription and self-focusing. Light Induced self inscribed (LISI) waveguides were revealed by wet etching. Under certain conditions, self-inscription exhibited optical beating or became chaotic, and filamentation was observed. Composite waveguides of nanoplasmonic particles and rare earth doped nanoparticles were written by LISI.