Nowadays, there is a great development in electric vehicle production and utilization. It has no pollution, high efficiency, low noise, and low maintenance. However, the charging stations, required to charge the electric vehicle batteries, impose high energy demand on the utility grid. One way to overcome the stress on the grid is the utilization of renewable energy sources such as photovoltaic energy. The utilization of standalone charging stations represents good support to the utility grid. Nevertheless, the electrical design of these systems has different techniques and is sometimes complex. This paper introduces a new simple analysis and design of a standalone charging station powered by photovoltaic energy. Simple closed-form design equations are derived, for all the system components. Case-study design calculations are presented for the proposed charging station. Then, the system is modeled and simulated using Matlab/Simulink platform. Furthermore, an experimental setup is built to verify the system physically. The experimental and simulation results of the proposed system are matched with the design calculations. The results show that the charging process of the electric vehicle battery is precisely steady for all the PV insolation disturbances. In addition, the charging/discharging of the energy storage battery responds perfectly to store and compensate for PV energy variations.

A new simple analytical and closed-form solution for the harmonic content injected in the five-level inverters at low switching control technique is proposed. The equations of the fundamental and the third harmonic are formulated and solved. The switching angles have been calculated to fix the fundamental voltage at a specified value and cancel the third-order harmonic. Two approaches have been proposed based on the modulation index. The proposed method can be feasible for a wide range of modulation index.

<p>This paper presents an effective single phase grid connected photovoltaic PV system based on High Efficiency and Reliable Inverter Concept HERIC transformerless inverter.  dc-dc boost converter controlled by incremental conductance IC maximum power point tracker MPPT is employed to achieve the maximum extraction power of the PV panels.  Proportional integral PI controller controls the output voltage of the boost converter to meet the utility grid requirements.  LCL filter is utilized to keep the inverter voltage very close to sinusoidal shape.   Employing the HERIC transformerless inverter reduces significantly the ground leakage current beyond safe limits.  Semiconductors losses are studied to investigate the efficiency of the proposed system at different insolation levels.  Simulation results verify the high performance of the proposed system when considering leakage current and system efficiency.</p>

Recently, micro-grids (MGs) have had a great impact on power system issues due to their clear environmental and economic advantages. This paper proposes an equilibrium optimizer (EO) technique for solving the energy management problem of MGs incorporating energy storage devices concerning the emissions from renewable energy sources (RES) of MGs. Because of the imprecision and uncertainties related to the RESs, market prices, and forecast load demand, the optimization problem is described in a probabilistic manner using a 2m + 1 point estimation approach. Then, the EO approach is utilized for solving the probabilistic energy management (EM) problem. The EM problem is described according to the market policy on the basis of minimizing the total operating cost and emission from RESs through optimal settings of the power generated from distributed generators (DGs) and grids connected under the condition of satisfying the operational constraints of the system. The proposed EO is evaluated based on a grid-connected MG that includes energy storage devices. Moreover, to prove the effectiveness of the EO, it is compared with other recently meta-heuristic techniques. The simulation results show acceptable robustness of the EO for solving the EM problem as compared to other techniques.

This paper proposes an asymmetrical cascaded single phase H-bridge inverter. The proposed inverter consists of two modules with unequal and isolated dc sources. Each module is composed of dc source, conventional four switches H-bridge and single bidirectional switch. To increase the output voltage levels, the tertiary ratio, 1:3, between its two dc sources is adopted. Both the fundamental frequency and the multicarrier pulse width modulation (PWM) control schemes are employed to generate switches signals. By controlling the inverter modulation index, the proposed inverter can generate an output voltage having up to seventeen levels by using only two modules. The proposed topology has also the feature of modularity which means that it can be extended to any levels by adding new modules. The proposed topology is simulated using an inductive load and some selected simulation results have been provided to validate the proposed inverter.

In this paper, the closed loop speed controller parameters are optimized for the permanent magnet synchronous motor (PMSM) drive on the basis of the indirect field-oriented control (IFOC) technique. In this derive system under study, the speed and current controllers are implemented using the fractional order proportional, integral, and derivative (FOPID) controlling technique. FOPID is considered as efficient techniques for ripple minimization. The hybrid grey wolf optimizer (HGWO) is applied to obtain the optimal controllers in case of implementing conventional PID as well as FOPID controllers in the derive system. The optimal controller parameters tend to enhance the drive response as ripple content in speed and current, either during steady state time or transient time. The drive system is modeled and tested under various operating condition of load torque and speed. Finally, the performance for PID and FOPID are evaluated and compared within MATLAB/Simulink environment. The results attain the efficacy of the operating performance with the FOPID controller. The result shows a fast response and reduction of ripples in the torque and the current.

This study proposes a classical control algorithm for solving the transcendental set of equations for the unequal DC sources of five-level multilevel inverters (MLIs). Such sources can be generated from renewable energy sources. Two DC sources with different values are used to produce an output voltage with five levels. Then, a set of two transcendental equations is formulated with two targeted functions to control the fundamental component and cancel the stipulated single harmonic order. The proposed solution uses a simple classical proportional control with two loops to generate two switching angles. The first switching angle is assigned with an initial value, whereas the second one is calculated from the inner loop. The outer loop is used to cancel the specified harmonic by sending the error signal to the proposed proportional control that tunes the switching angles. The proposed algorithm is easy, fast, and accurate, and has a wide-range solution in terms of modulation index (MI ) and input DC source ratio (x=V1V2≤1). The proposed algorithm is tested for a wide range of MI and x to verify its feasibility. Moreover, several simulation and laboratory tests are presented to further validate the applicability of the proposed approach.

No abstract