No abstract

No abstract

No abstract

No abstract

Multi-walled WS 2 nanotubes (NTs) with lengths ranging from 2 to 65 μm and widths from 50 to 110 nm were synthesized in a horizontal quartz-made reactor by a process yielding NTs with aspect ratios (ARs) between ∼40 and >1000. The NTs obtained were thermally stable in air up to 400 °C but were oxidized within the temperature range 400−550 °C to produce yellow WO 3 particles. Critically, 400 °C is well above the temperature used to mix additives with the majority of meltprocessable polymers. The hydrophilic WS 2 NTs were easily dispersed in poly(lactic) acid (PLA) using a twin-screw extruder, but the shear stresses applied during melt mixing resulted in chopping of the NTs such that the AR decreased by >95% and the tensile mechanical properties of the PLA were unchanged. Although the as-extruded unfilled PLA was >99% amorphous, the much-shortened WS 2 NTs had a significant effect on the crystallization behavior of PLA, inducing heterogeneous nucleation, increasing the crystallization temperature (T c ) by ∼3 °C and the crystalline content by 15%, and significantly increasing the rate of PLA crystallization, producing smaller and more densely packed spherulites. The reduction in the AR and the nucleating effect of WS 2 NTs for PLA are critical considerations in the preparation, by melt mixing, of composites of rigid 1D NTs and polymers, irrespective of the target application, including bone tissue engineering and bioresorbable vascular scaffolds.