Purpose Water/Al2O3 nanofluid with volume fractions of 0, 0.3 and 0.06 was investigated inside a rectangular microchannel. Jet injection of nanofluid was used to enhance the heat transfer under a homogeneous magnetic field with the strengths of Ha = 0, 20 and 40. Both slip velocity and no-slip boundary conditions were used. Design/methodology/approach The laminar flow was studied using Reynolds numbers of 1, 10 and 50. The results showed that in creep motion state, the constricted cross section caused by fluid jet is not observable and the rise of axial velocity level is only because of the presence of additional size of the microchannel. By increasing the strength of the magnetic field and because of the rise of the Lorentz force, the motion of fluid layers on each other becomes limited. Findings Because of the limitation of sudden changes of fluid in jet injection areas, the magnetic force compresses the fluid to the bottom wall, and this behavior limits the vertical velocity gradients. In the absence of a magnetic field and under the influence of the velocity boundary layer, the fluid motion has more variations. In creeping velocities of fluid, the presence or absence of the magnetic field does not have an essential effect on Nusselt number enhancement. Originality/value In lower velocities of fluid, the effect of the jet is not significant, and the thermal boundary layer affects the entire temperature field. In this case, for Hartmann numbers of 40 and 0, changing the Nusselt number on the heated wall is similar.

In the current study, laminar heat transfer and direct fluid jet injection of oil/MWCNT nanofluid were numerically investigated with a finite volume method. Both slip and no-slip boundary conditions on solid walls were used. The objective of this study was to increase the cooling performance of heated walls inside a rectangular microchannel. Reynolds numbers ranged from 10 to 50; slip coefficients were 0.0, 0.04, and 0.08; and nanoparticle volume fractions were 0-4%. The results showed that using techniques for improving heat transfer, such as fluid jet injection with low temperature and adding nanoparticles to the base fluid, allowed for good results to be obtained. By increasing jet injection, areas with eliminated boundary layers along the fluid direction spread in the domain. Dispersing solid nanoparticles in the base fluid with higher volume fractions resulted in better temperature distribution and Nusselt number. By increasing the nanoparticle volume fraction, the temperature of the heated surface penetrated to the flow centerline and the fluid temperature increased. Jet injection with higher velocity, due to its higher fluid momentum, resulted in higher Nusselt number and affected lateral areas. Fluid velocity was higher in jet areas, which diminished the effect of the boundary layer.

Purpose In this paper, the forced convection heat transfer of the nanofluid composed of water and AL2O3 nanoparticles is simulated in a two-dimensional horizontal microchannel by injecting the lower wall. The upper wall of the microchannel is 303 K at temperature TH. On the lower wall of the microchannel, there are three holes for flow injection. Other parts of the wall are insulated. In this paper, the effect of parameters such as Reynolds number, slip coefficient and volume fraction of nanoparticles is investigated. Design/methodology/approach The boundary condition of the slip velocity is considered on the upper and lower walls of the microchannel. In this work, the flow of nanofluid in the microchannel is considered to be slow, permanent and Newtonian. In the present study, the effect of injection through the microchannel wall on the slip velocity is examined for the first time. Findings The results are also presented as velocity profiles and Nusselt number diagrams. It was found that the Nusselt number increases with increasing the amount of slip coefficient of velocity and the weight percentage of solid nanoparticles. The rate of this increase is higher in the high values of the Reynolds number. Originality/value A novel paper concerned the simulation of cross-flow injection effects on the slip velocity and temperature domain of a nanofluid flow inside a microchannel.

No abstract