The thermal properties of engine oil are important traits affecting the ability of the oil to transfer heat from the engine. The larger the thermal conductivity and specific heat, the more efficiently the oil will transfer heat. In this work, we measured the thermal conductivity and specific heat of a conventional mineral oil-based diesel engine lubricant and a Group V-based LHR diesel engine lubricant as a function of temperature. We also measured the specific heat of ethylene glycol. The measured values are compared with manufacturers’ data for typical heat transfer fluids. The Group V-based engine oil had a higher thermal conductivity and slightly lower specific heat than the mineral oil-based engine oil. Both engine oils had values comparable to high-temperature heat transfer fluids.
The focus of the study described herein is the characterization of the high-pressure hydraulic electronic unit injector (HEUI) and of the electronic unit injector (EUI) diesel injection systems. The characterization items include injection pressure, injection rate, injector response time, needle lift, start up injection transient, and dynamic discharge coefficient of the nozzles. Macroscopic and microscopic spray visualizations were also performed. The effects of injection conditions and nozzle configurations on injection characteristics were reviewed. Nozzle sac pressure was measured to correlate with the up-stream injection pressure. A LabVIEW data acquisition and controls system was implemented to operate the injection systems and to acquire and analyze data. For an HEUI system, based on the results of the study, it can be concluded that common-rail pressure and length of the injection rate-shaping pipe determine the injection pressure, while the pressure rising rate and injection duration determine the peak injection pressure; it was also found that the nozzle flow area, common-rail pressure, and the length of the rate-shaping pipe are the dominating parameters that control the injection rate, and the rate shape is affected mainly by common-rail pressure, especially the pressure rising rate and length of the rate-shaping pipe. Both injection pressure and ambient pressure affected the spray tip penetration significantly. The penetration increased corresponding to the increase of injection pressure or decrease of ambient pressure. The variation of spray penetration depends on the type of injection system, nozzle configuration, and ambient pressure. The large penetration variation observed on the HEUI sprays could be caused by eccentricity of the VCO (valve-covered-orifices) nozzle. The variation of the mini-sac nozzle was 50% less than that of the VCO nozzle. The near-field spray behavior was shown to be highly transient and strongly depended on injector design, nozzle configuration, needle lift and oscillation, and injection pressure.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.