This paper considers interaction of the human arm with "virtual" objects simulated mechanically by a planar robot. Haptic perception of spatial properties of objects is distorted. It is reasonable to expect that it may be distorted in a geometrically consistent way. Three experiments were performed to quantify perceptual distortion of length, angle and orientation. We found that spatial perception is geometrically inconsistent across these perceptual tasks. Given that spatial perception is distorted, it is plausible that motor behavior may be distorted in a way consistent with perceptual distortion. In a fourth experiment, subjects were asked to draw circles. The results were geometrically inconsistent with those of the length perception experiment. Interestingly, although the results were inconsistent (statistically different), this difference was not strong (the relative distortion between the observed distributions was small). Some computational implications of this research for haptic perception and motor planning are discussed.
Abstract-Mechanical impedance is the dynamic generalization of stiffness, and determines interactive behavior by definition. Although the argument for explicitly controlling impedance is strong, impedance control has had only a modest impact on robotic manipulator control practice. This is due in part to the fact that it is difficult to select suitable impedances given tasks. A spatial impedance controller is presented that simplifies impedance selection. Impedance is characterized using "spatially affine" families of compliance and damping, which are characterized by nonspatial and spatial parameters. Nonspatial parameters are selected independently of configuration of the object with which the robot must interact. Spatial parameters depend on object configurations, but transform in an intuitive, well-defined way. Control laws corresponding to these compliance and damping families are derived assuming a commonly used robot model. While the compliance control law was implemented in simulation and on a real robot, this paper emphasizes the underlying theory.
Notch hinges are flexural hinges used to make complex, precise mechanisms. They are typically modeled as single degree-of-freedom hinges with an associated joint stiffness. This is not adequate for all purposes. This paper computes the six degree-of-freedom stiffness properties of notch hinges using finite element methods. The results are parameterized in terms of meaningful design parameters.
Interactive control schemes, such as stiffness control and impedance control, are widely accepted as a means to actively accommodate environmental forces, but have not been widely applied. This is in part because well-known controllers are parametrized in a mathematically convenient, but nonintuitive way. “Spatial compliance control” is a Euclidean-geometrical version of compliance control that is parametrized in an intuitive way. A family of compliances is introduced with spatial transformation properties that simplify spatial reasoning aspects of compliance parameter selection. A control law is derived assuming that the robot consists of a serial linkage of rigid links actuated by variable-effort actuators.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.