Silver nanoparticles (Ag NPs) are becoming increasingly prevalent in consumer products as antibacterial agents. The increased use of Ag NP-enhanced products may lead to an increase in toxic levels of environmental silver, but regulatory control over the use or disposal of such products is lagging due to insufficient assessment on the toxicology of Ag NPs and their rate of release into the environment. In this article we discuss recent research on the transport, activity and fate of Ag NPs at the cellular and organismic level, in conjunction with traditional and recently established methods of nanoparticle characterization. We include several proposed mechanisms of cytotoxicity based on such studies, as well as new opportunities for investigating the uptake and fate of Ag NPs in living systems.

Foodborne illnesses are a growing concern for the food industry and consumers, with millions of cases reported every year. Consequently, there is a critical need to develop rapid, sensitive, and inexpensive techniques for pathogen detection in order to mitigate this problem. However, current pathogen detection strategies mainly include time-consuming laboratory methods and highly trained personnel. Electrochemical in-field biosensors offer a rapid, low-cost alternative to laboratory techniques, but the electrodes used in these biosensors require expensive nanomaterials to increase their sensitivity, such as noble metals (e.g., platinum, gold) or carbon nanomaterials (e.g., carbon nanotubes, or graphene). Herein, we report the fabrication of a highly sensitive and label-free laser-induced graphene (LIG) electrode that is subsequently functionalized with antibodies to electrochemically quantify the foodborne pathogen Salmonella enterica serovar Typhimurium. The LIG electrodes were produced by laser induction on polyimide film in ambient conditions, and hence circumvent the need for hightemperature, vacuum environment, and metal seed catalysts commonly associated with graphene-based electrodes fabricated via chemical vapor deposition processes. After functionalization with Salmonella-antibodies, the LIG biosensors were able to detect live Salmonella in chicken broth across a wide linear range (25 to 10 5 CFU mL -1 ) and with a low detection limit (13 ± 7 CFU mL -1 ; n = 3, mean ± standard deviation). These results were acquired with an average response time of 22 minutes without the need for sample preconcentration or redox labeling techniques. Moreover, these LIG immunosensors displayed high selectivity as demonstrated by non-significant response to other bacteria strains. These results demonstrate how LIG-based electrodes can be used for electrochemical immunosensing in general and, more specifically, could be used as a viable option for rapid, low-cost pathogen detection in food processing facilities before contaminated foods reach the consumer.

Flexible graphene electronics are rapidly gaining interest, but their widespread implementation has been impeded by challenges with ink preparation, ink printing, and post-print annealing processes. Laser-induced graphene (LIG) promises a facile alternative by creating flexible graphene electronics on polyimide substrates through a one-step laser writing fabrication method. Herein we demonstrate the use of LIG, created through a low-cost UV laser, for electrochemical ion selective sensing of plant-available nitrogen (i.e., both ammonium and nitrate ions: NH4+ and NO3-) in soil samples. The laser used to create the LIG was operated at distinct pulse rates (10, 20, 30, 40, and 50 ms) in order to maximize the LIG electrochemical reactivity. Results illustrated that a laser pulse rate of 20 ms led to a high percentage of sp2 carbon (77%) and optimal peak oxidation current of 120 uA during ferricyanide cyclic voltammetry. Therefore, LIG electrodes created with a 20 ms pulse rate were consequently functionalized with distinct ionophores specific to NH4+(nonactin) or NO3-(tridodecylmethylammonium nitrate) within polyvinyl chloride (PVC)-based membranes to create distinct solid contact ion selective electrodes (SC-ISEs) for NH4+ and NO3-ion sensing respectively. The LIG SC-ISEs displayed near Nernstian sensitivities of 51.7 ± 7.8 mV/decade (NH4+) and -54.8 ± 2.5 mV/ decade (NO3-), detection limits of 28.2 ± 25.0 uM (NH4+) and 20.6 ± 14.8 uM (NO3-), low long-term drift of 0.93 mV/hr (NH4+) sensors and -5.3 μV/hr (NO3-) sensors and linear sensing ranges within 10-5-10-1 M for both sensors. Moreover, soil slurry sensing was performed and recovery percentages of 96% and 95% were obtained for added NH4+and NO3-, respectively. These results, combined with a facile fabrication that does not require metallic nanoparticle decoration, make these LIG electrochemical sensors appealing for a wide range of in field or point-of-service applications for soil health management. ABSTRACTFlexible graphene electronics are rapidly gaining interest, but their widespread implementation has been impeded by challenges with ink preparation, ink printing, and postprint annealing processes. Laser-induced graphene (LIG) promises a facile alternative by creating flexible graphene electronics on polyimide substrates through a one-step laser writing fabrication method. Herein we demonstrate the use of LIG, created through a low-cost UV laser, for electrochemical ion selective sensing of plant-available nitrogen (i.e., both ammonium and nitrate ions: NH 4 + and NO 3 -metallic nanoparticle decoration, make these LIG electrochemical sensors appealing for a wide range of in-field or point-of-service applications for soil health management.

SUMMARYIndole-3-acetic acid (IAA) is a primary phytohormone that regulates multiple aspects of plant development. Because polar transport of IAA is an essential determinant of organogenesis and dynamic tropic growth, methods to monitor IAA movement in vivo are in demand. A self-referencing electrochemical microsensor was optimized to non-invasively measure endogenous IAA flux near the surface of Zea mays roots without the addition of exogenous IAA. Enhanced sensor surface modification, decoupling of acquired signals, and integrated flux analyses were combined to provide direct, real time quantification of endogenous IAA movement in B73 maize inbred and brachytic2 (br2) auxin transport mutant roots. BR2 is localized in epidermal and hypodermal tissues at the root apex. br2 roots exhibit reduced shootward IAA transport at the root apex in radiotracer experiments and reduced gravitropic growth. IAA flux data indicates that maximal transport occurs in the distal elongation zone of maize roots, and net transport in/out of br2 roots was decreased compared to B73. Integration of short term real time flux data in this zone revealed oscillatory patterns, with B73 exhibiting shorter oscillatory periods and greater amplitude than br2. IAA efflux and influx were inhibited using 1-N-naphthylphthalamic acid (NPA), and 2-naphthoxyacetic acid (NOA), respectively. A simple harmonic oscillation model of these data produced a correlation between modeled and measured values of 0.70 for B73 and 0.69 for br2. These results indicate that this technique is useful for real-time IAA transport monitoring in surface tissues and that this approach can be performed simultaneously with current live imaging techniques.