No abstract
Emerging antibiotic resistance necessitates the development of new therapeutic approaches. Many studies have reported the antimicrobial activity of diclofenac sodium (DIC) and chitosan nanoparticles (CNPs). Hence, this study aimed to prepare non-antibiotic DIC-loaded CNPs (DIC.CNPs) and characterize their in vitro antibacterial activity. DIC.CNPs were prepared from low and high molecular weight (LMW and HMW, respectively) chitosan using an ionic gelation method. Prepared NPs were characterized, and their antibacterial activity against gram-positive Staphylococcus aureus and Bacillus subtilis was evaluated using the agar diffusion and broth dilution methods. The particle size, polydispersity index (PDI), and encapsulation efficiency of the formulated DIC.CNPs increased with increasing MW of chitosan. The prepared NPs showed a narrow size distribution with low PDI values (0.18 and 0.24) and encapsulation efficiency (29.3% and 31.1%) for LMW.DIC.CNPs and HMW.DIC.CNPs, respectively. The in vitro release profile of DIC from the DIC.CNPs was biphasic with a burst release followed by slow release and was influenced by the MW of chitosan. DIC.CNPs exhibited significantly higher antibacterial activity against S. aureus (minimum inhibitory concentration [MIC90] LMW.DIC.CNPs = 35 µg/mL and MIC90 HMW.DIC.CNPs = 18 µg/mL) and B. subtilis (MIC90 LMW.DIC.CNPs = 17.5 µg/mL and MIC90 HMW.DIC.CNPs = 9 µg/mL) than DIC alone did (MIC90 DIC = 250 and 50 µg/mL against S. aureus and B. subtilis, respectively). The antibacterial activity was influenced by pH and the MW of chitosan. Collectively, these results may suggest the potential usefulness of DIC.CNPs as non-antibiotic antibacterial agent necessitating further future studies to asses the stability of DIC.CNPs prepared.
The emergence of Neisseria gonorrhoeae strains that are resistant to the most commonly used antibiotics represents a great concern for global public health. This challenges the effectiveness of clinical treatment regimens and demands the development of alternative antigonococcal agent. In this regard, chitosan nanoparticles (CNPs) are known to have antimicrobial activity against a wide range of pathogens. Thus, they have become a potential candidate for combatting this era of multi-drug resistance. This study aims to formulate CNPs, characterize their physicochemical properties, and examine their antimicrobial activity against gonococcus. Materials and Methods: The ionic gelation method was used to prepare CNPs of different concentrations. Characterization for their particle size (PZ), polydispersity index (PDI), and zeta potential (ZP) was performed. The anti-microbial activity of CNPs was investigated against 13 WHO N. gonorrhoeae reference strains, using the broth dilution method. Cytotoxicity of CNPs and their effect on bacterial adhesion to HeLa cells were investigated. Results: The average PZ and ZP of the prepared NPs were increased when the concentration of chitosan was increased from 1 to 5 mg/mL and found to be in the range of 193 nm ± 1.9 to 530 nm ± 13.3, and 14 mV ± 0.5 to 20 mV ± 1, respectively. Transmission electron microscopes (TEM) images revealed spherical NPs, and the NPs had a low PDI value of ≤0.27. The formed CNPs produced antibacterial activity against all tested strains, including those resistant to multiple antibiotics, with a minimum inhibitory concentration (MIC 90) of 0.16 to 0.31 mg/ mL and a minimum bactericidal concentration (MBC) of 0.31 to 0.61 mg/mL. Of note, at all MIC 90 and MBC, the CNPs had no significant cytotoxic effect on HeLa cells and reduced bacterial adhesion to these cells at MBC doses. Conclusion: The present work findings suggest the potential of the CNPs for the treatment of gonorrhoea.
The needs for safe, therapeutically effective antidiarrheal combination continuously lead to effective treatment. When administered simultaneously, metronidazole-kaolin interactions have been reported by FDA but not studied. This paper is the first to study metronidazole-kaolin interactions. Adsorption isotherms of a metronidazole-kaolin antidiarrheal combination from aqueous solutions at an in vivo simulated pH conditions were obtained at 37 ± 0.5 °C. Langmuir constants for the adsorption are 10.8225, 41.3223 mg g(-1) and 11.60, 2.56 l g(-1) aimed at the monolayer capacity, and the equilibrium constant at pH 1.2 and 6.8, respectively. pH effect on adsorption of known concentration of metronidazole by kaolin was also studied over the range 1.2-8. A gradual increase in the adsorbed amount was noted with increasing the pH. Elution studies by different eluents showed that drug recovery from adsorbent surface was pH-dependent via competitive mechanism. The elution followed the sequence: 0.1 M HCl > 0.1 M NaCl > H2O. Adsorption-desorption studies revealed physical adsorption. The equilibrium concentration of metronidazole decreased as the adsorbent concentration was increased in the systems. The dissolution profiles (USP) of commercially available tablets (Riazole® 500 mg) were obtained alone and in the presence of either (ORS®) rehydration salts and 9 or 18 g of kaolin powder. The percentage drug released versus time: 95.01% in 25 min, 101.02% in 30 min, 67.63% in 60 min, 60.59% in 60 min, respectively. The percentage drug released versus time was increased with ORS® due to common ion effect [Cl(-)], while, it was decreased with kaolin due to adsorption. The mechanism of reaction of Riazole® (500 mg) tablets in the different dissolution media, confirms with Korsmeyer-Peppas model. The interaction between metronidazole and kaolin was characterized by melting point determinations, differential scanning calorimetry analysis and infrared spectroscopy. The results obtained were suggestive of physical interaction between metronidazole and kaolin.
Background: Streptococcus pneumoniae remains a major cause of community-acquired pneumonia, meningitis, and other diseases, contributing significantly to high morbidity and mortality worldwide. Although it responds to antibiotics, their use is becoming limited due to the rise in antibiotic resistance, which necessitates the development of new therapeutics. Nanotechnology is used to counteract antimicrobial resistance. In this regard, polymeric nanoparticles (NPs) made of natural, biodegradable, biocompatible, and cationic polymers such as Chitosan (CNPs) exhibit wide-spectrum antimicrobial activity. Therefore, this study aimed to prepare CNPs, characterize their physiochemical characteristics: particle size (PZ), polydispersity index (PDI), and zeta potential (ZP), and investigate their antimicrobial activity against Streptococcus pneumoniae TIGR4 (virulent serotype 4) and its capsular mutant (∆cps). Methods: CNPs were prepared at 1, 2.5, and 5 mg/mL concentrations using the ion gelation method. Then, PZ, PDI, and ZP were characterized using a Zetasizer. Transmission electron microscopy (TEM) was used to visualize the CNP’s morphology. Broth and agar dilution methods were used to assess their antimicrobial activity. Cytotoxicity of prepared NPs on A549 cells and their effect on pneumococcal hemolysis were also investigated. Results: Spherical CNPs were produced with PZ ranging from 133.3 nm ± 0.57 to 423 nm ± 12.93 PDI < 0.35, and ZP from 19 ± 0.115 to 27 ± 0.819. The prepared CNPs exhibited antibacterial activity against TIGR4 and its capsule mutant with a minimum inhibitory concentration (MIC90) of 0.5 to 2.5 mg/mL in a non-acidic environment. The hemolysis assay results revealed that CNPs reduced bacterial hemolysis in a concentration-dependent manner. Their mammalian cytotoxicity results indicated that CNPs formed from low concentrations of Chitosan (Cs) were cytocompatible. Conclusion: Nanochitosan particles showed anti-pneumococcal activity regardless of the presence of capsules. They resulted in a concentration-dependent reduction in bacterial hemolysis and were cytocompatible at a lower concentration of Cs. These findings highlight the potential of CNPs in the treatment of pneumococcal diseases.
The aim of this study was to compare metronidazole tablets (500 mg) and infusions (500 mg/100 mL) obtained from Saudi and Egyptian suppliers. Evaluation of the tablets included weight variation, hardness, friability, drug content, disintegration time, and dissolution profiles. Stability of the tablets in their original packages after 3-month storage at various temperatures (75% relative humidity) was evaluated, and degradation kinetics was determined. The infusion solutions underwent accelerated stability testing. The Q 10 method was used to estimate the shelf life of metronidazole infusions at room temperatures (75% relative humidity) of various climates. Results revealed that all tablets complied with USP specifications, and degradation was slowest at room temperature (20 °C). The mechanism of drug release for all tablets at all temperatures conformed to the Korsmeyer-Peppas model. Metronidazole intravenous infusion solutions stored at 40 °C or 50 °C for 90 days exhibited good stability. The studied Saudi infusion brand is more stable than Egyptian one. The metronidazole tablets and infusion solutions complied with USP specifications and showed similar results in quality control testing. Standard quality control measures should be maintained to ensure safety and efficacy of drug products, especially in climates with extreme temperatures.
When antacids are administered with other drugs, they can alter the absorption, bioavailability, and/or excretion of concomitantly administered drugs. This study aims to characterize the in vitro interaction between different formulations of mebeverine HCl and magnesium trisilicate antacids and salts used for electrolyte-replacement therapy. The dissolution profiles of different formulations of mebeverine alone and in the presence of aluminium/magnesiumcontaining antacids and salts were studied. The release profiles of the drugs and the model and mechanisms of drug release were determined using differential scanning calorimetry and infrared techniques. The loss of mebeverine HCl in each case appeared to be caused by absorption. The calorimetry and infrared results suggest that mebeverine HCl interacts with the antacids and with Movicol. These results should be added to the in vitro drug-drug interaction chart. It is advisable to administer other drugs at least 0.5-1.0 h before antacid ingestion to ensure consistent absorption and effect and to avoid potential interactions.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.