Hydroxyapatite coatings have been proven to improve the osteointegration of metal implants through a tight binding to the bone mineral phase as well as through favorable osteoblast adhesion and proliferation onto the implant surface. However, hydroxyapatite coatings are not stable and they tend to delaminate from the metal surface when challenged by the mechanical stresses experienced by the implant. Recently, a new multiphase anodic spark deposition (ASD) method has been optimized where the formation of a thick oxide film is followed by the deposition of a calcium phosphate mineral phase and its etching by alkali. The data in this paper demonstrate that this novel type of coating, BioSpark, improves the material osteointegration potential when compared to conventional ASD while offering more mechanical stability. A faster mineralization was obtained by incubation in simulated body fluids and osteoblasts showed better adhesion, proliferation, differentiation, and collagen production. These performances were related to the surface morphology, to the film calcium/phosphate ratio and its surface oxygen content, as well as to a preferential binding of structural proteins such as fibronectin.

No abstract

The present study assessed in vitro the short-term cellular response to surface physico-chemical properties of a new, purposed bioactive surface treatment called BioSpark performed on simply machined and on sand-blasted titanium. Material characterisation was carried out using scanning electron microscopy, energy dispersion spectroscopy, laser profilometry, and thin film X-ray diffraction. The in vitro biological study showed a suitable cellular response with adhesion and spreading level comparable for all the tested specimens. The proliferation analysis demonstrated that all the surfaces successfully supported cellular colonisation; in particular, higher cellular proliferation activity was observed on the BioSpark-treated materials, with values higher than machined titanium. The results suggest that the BioSpark treatment represents a smart way to enhance osteoblastic cellular colonisation and thus improve osteointegration processes of machined and sandblasted titanium for orthopaedic and dental implants.

The effect of a new three-step anodic spark deposition process, labeled TiSpark, including two consecutive treatments performed first in a P solution and second in Ca solution, followed by an additional alkali etching step, was investigated for the improvement of osseointegration of commercial grade 2 titanium, machined (Ti) or Al(2)O(3) sandblasted (Ti-SA), cylindrical implants (12 mm in length and 4 mm in diameter) in cortical bone of 12 adult sheep. Histomorphometric and microhardness measurements were carried out at each experimental time (4, 8, and 12 weeks) to quantify the bone-to-implant contact around the implants as well as the newly bone hardness and bone maturation index. TiSpark treated surfaces were covered by a thick layer of crystalline anatase TiO(2) and by a further Ca/P layer. Bone tissue extends and grows on the surface of the TiSpark treated implants without any fibrous tissue, enhancing the short-term osseointegration properties of implant. Bone mineralization rate was also influenced by the chemical composition of implants and sandblasted materials presented the lowest bone maturation rate at the interface. Data suggests that the TiSpark treatment produces a modification of the Ti surface, which presents good bioactivity and may be suitable for achieving a stable implant osseointegration.

No abstract