No abstract

No abstract

One strategy for minimising corrosive attack on carbon steel involves the application of hybrid coatings rich in rare earths, on the basis of their low toxicity and environmental sustainability. Tetraethoxysilane (TEOS) and 3-glycidoxypropyl-trimethoxysilane (GPTMS) were each used here as precursors, together with various quantities of colloidal silica suspension, to improve barrier properties of the coatings. Ce(NO3)(3)center dot 6H(2)O was added as a source of Ce(III) for further inhibition of corrosion. The corrosion resistance of each kind of sample was evaluated using potentiodynamic polarisation measurements and electrochemical impedance spectroscopy (EIS) in 0.35 wt.% NaCI solution. The electrochemical behaviour at various immersion times was modelled by equivalent circuits to demonstrate the effect of silica nanoparticle loading on corrosion. Additional testing was performed under harsh conditions of salt spray chamber. The microstructure and composition of sol-gel coatings were characterised by scanning electron microscopy and energy dispersive X-ray spectroscopy (SEM/EDS), focused-ion beam SEM/EDS analysis, X-ray photoelectron spectroscopy and confocal microscopy. (C) 2015 Elsevier B.V. All rights reserved.Postprint (published version

A series of nanoindentation tests has been carried out with TiO2 films produced by physical vapour deposition (PVD) under different conditions. Films with different microstructures and crystallographic structures have been prepared by changing experimental parameters such as the temperature of the substrate, the deposition angle (by the so-called glancing angle physical vapour deposition, GAPVD) or by exposing the growing film to a beam of accelerated ions. The obtained results of hardness and Young's modulus depict interesting correlations with the microstructure and structure of the films providing a general picture for the relationships between these characteristics and their mechanical properties. Different models have been used to extract Young's modulus and hardness parameters from the experimental nanoindentation curves. The obtained results are critically discussed to ascertain the ranges of validity of each procedure according to the type of sample investigated.

No abstract