Lithium-Ion battery success can be defined by a series of measureable characteristics. Two important characteristics that have been difficult to fully explore are the ionic [1] and electronic tortuosity. Micro-N-line probes were previously developed [2][3] in order to accurately measure electronic thin-film conductivity on a micro-scale. Multiple iterations of the probe have been produced, tested and verified. In order to meet the final goal of a probe that could be implemented in any laboratory or production line, changes to the substrate, probe, and sizing were necessary. The final design also required substantial changes to methodology as well as the conductivity inversion calculations. The new probe is produced on a flexible substrate for a fraction of the original production cost and a fraction of the original production time. Here we show that the new probe has been used to test battery films and measure battery film heterogeneity on a mm scale (See Figure 1). COMSOL modeling of the battery under testing conditions shows minimal influence by the battery current collector on measurements; this allows for non-destructive measurements of standard battery films. The probe shows key advances in robustness and flexibility which allows for implementation on a rolling production line. New affordable stages have been developed to produce reliable measurements. High and low conductivity locations are still able to be found which is consistent with previous results. Acknowledgements This research is supported by the US Department of Energy through the Advanced Battery Material Research (BMR) Program. References [1] S.W. Peterson and D.R. Wheeler, "Direct Measurements of effective electronic transport in porous li-ion electrodes", Journal of the Electrochemical Society, vol. 161, no. 14, A2175-A2181, 2014 [2] B.J. Lanterman, A.A. Riet, N.S. Gates, J.D. Flygare, A.D. Cutler, J.E. Vogel, D.R. Wheeler, and B.A. Mazzeo, "Micro-four-line probe to measure electronic conductivity and contact resistance of thin-film battery electrodes", Journal of the Electrochemical Society, vol. 162, no. 10, A2145-A2151, 2015 [3] M.M. Forouzan, C.-W. Chao, D. Bustamante, B.A. Mazzeo, and D.R. Wheeler, "Experiment and simulation of the fabrication process of lithium-ion battery cathodes for determining microstructure and mechanical properties", Journal of Power Sources, vol. 312, pp. 172-183, 2016 Figure 1: Figure (a) showing the new probe, (b) the COMSOL model of the new probe, and (c) the results of a simple electrode conductivity mapping experiment run on a standard NMC TODA523 electrode. Figure 1
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.